Polaris P2000i, P1000i Safety Warnings and Precautions, General, Before and During Operation

Page 8

SAFETY

Safety Warnings and Precautions

IMPORTANT SAFEY INSTRUCTIONS. SAVE THESE INSTRUCTIONS.

Failure to follow recommended precautions and procedures could result in severe injury or death. Always read all safety precautions and follow all operation, inspection, and maintenance procedures outlined in this manual.

General

•Read and understand all of the safety and operating information in this manual and on the product before using the machine. Use the generator only as described in this manual.

•Understand and follow all inspection and maintenance procedures outlined in this manual. Following these procedures will ensure that the generator remains in safe operating condition.

•Turn off the petrol valve and close the fuel cap vent when the generator is not in use.

It is the responsibility of the owner to ensure that all users of this generator are fully informed of the safety and operating information prior to use.

Before and During Operation

•Preform all Pre-Inspection activities as shown on page 25 of this manual. Inspect and tighten all parts regularly. Ensure the generator does not have any damaged, loose, or missing parts before use. All defects should be corrected before use. Do not operate the generator if it has been dropped or damaged until all defective parts have been repaired.

•Do not place any flammable materials near the generator.

•Never start the generator or let it run in an enclosed area. Exhaust vapors are poisonous and can cause loss of consciousness or death in a short time. Keep the generator away from buildings and other equipment during operation.

7

Image 8

Contents Polaris Power Table of Contents Introduction WelcomeIntended Use Safety Precautions Signal Words and Safety Terms Alcohol or Drug USEIdentification Numbers and Locations P1000iP2000iSafety Safety Warnings and PrecautionsGeneral Before and During OperationFire Safety Operator Safety Fuel Safety Carbon Monoxide Safety Electrical Safety Extension Cord Information Equipment ModificationsSafety Labels and Locations Carbon Monoxide WarningOutdoor Use only Danger Label Hot Exhaust CautionSafety Controls and Features Generator ComponentsControl Panel Components P1000i P2000iEngine Fuel Switch Choke LeverFuel Tank Cap Vent Lever Starter Recoil GripSmart Throttle Switch DC Receptacle and FuseAC Receptacles Indicator PanelGround Terminal Overload Protector Reset Switch Parallel ReceptaclesFirst USE Instructions Adding Engine OilFuel Recommendation Adding Fuel Pre-Operation Checklist PRE-OPERATION InspectionSafe Operating Precautions OperationFuel Recommendations RefuelingRemove the fuel tank cap a Before Starting the Engine Starting the EnginePosition the engine switch to on Stopping the Engine AC Operation AC Capacity Wattage Reference Table Power Management DC OperationOperation Disconnecting the Battery Charging Cable Smart Throttle SystemStandby Power Connections to a Building Electrical SystemParallel operation procedure Parallel Generator OperationShutting off the generators High Altitude Use Carburetor ModificationAlterations Emission Control System InformationSource of Emissions Problems Affecting Emissions Replacement PartsMaintenance Importance of MaintenanceMaintenance Safety Safety PrecautionsPeriodic Maintenance Periodic Maintenance ChartOpening the Service Door Initial Maintenance Fuel SystemHour Initial Break-In Fuel Line InspectionOFF Oil Level Inspection Engine OilOil Recommendation Oil Change Procedure Maintenance Air Filters Air Filter InspectionAir Filter Cleaning Air Filter ReplacementSpark Plug Inspection and Replacement Spark PlugGap should be 0.6 0.7 mm Transporting the Generator Transportation and StorageTransportation Storage Storage PreparationAccessing the Fuel Tank Draining Fuel from the Fuel Tank and Carburetor Fogging the Engine Storage Precautions Removing from StorageSpecifications General SpecificationsPolaris Lubricants and Maintenance Products Modified coefficient table of ambient condition powerWiring Diagrams P1000i Wiring DiagramP2000i Wiring Diagram Red Gray Brown White BlackTroubleshooting Troubleshooting SymptomsEngine Will Not Turn Over Engine Turns Over, but Will Not StartEngine Lacks Power Engine BackfiresEngine Pings or Knocks Engine Runs Irregularly, Stalls, or MisfiresNo Power at DC Receptacle Possible Lean Solution Fuel CauseNo Power at AC Receptacles Engine Stops or Loses PowerWarranty About this Warranty Document Warranty Registration FormWarranty Period Warranty Exclusions Polaris Power Generator Owner Responsibility Important Notice Maintenance LOG DATE/HOURS Service Comments Supplier Permormed TechnicianIndex Label LocationIndex PMS