Polaris P2000i, P1000i manual Maintenance

Page 52

MAINTENANCE

Engine Oil

Oil Change Procedure

7.	Fill the oil to the high limit mark (B)			B
	on the dipstick (A).
8.	Start the engine and let it run for 1 or
8.	Start the engine and let it run for 1 or
	2 minutes. Stop the engine and look
	2 minutes. Stop the engine and look

for leaks.

9.Re-check the oil level on the dipstick (A) and add oil as needed to bring the level to the upper mark (B) on the dipstick.

10.Re-install the dipstick (A).

11.Re-install the service door.

12.Wash hands with soap and water after handling used oil.

51

Image 52

Contents Polaris Power Table of Contents Introduction WelcomeIntended Use Safety Precautions Signal Words and Safety Terms Alcohol or Drug USEIdentification Numbers and Locations P1000iP2000iSafety Safety Warnings and PrecautionsGeneral Before and During OperationFire Safety Operator Safety Fuel Safety Carbon Monoxide Safety Electrical Safety Extension Cord Information Equipment ModificationsSafety Labels and Locations Carbon Monoxide WarningOutdoor Use only Danger Label Hot Exhaust CautionSafety Controls and Features Generator ComponentsControl Panel Components P1000i P2000iEngine Fuel Switch Choke LeverFuel Tank Cap Vent Lever Starter Recoil GripSmart Throttle Switch DC Receptacle and FuseGround Terminal Indicator PanelAC Receptacles Overload Protector Reset Switch Parallel ReceptaclesFirst USE Instructions Adding Engine OilFuel Recommendation Adding Fuel Pre-Operation Checklist PRE-OPERATION InspectionSafe Operating Precautions OperationFuel Recommendations RefuelingRemove the fuel tank cap a Before Starting the Engine Starting the EnginePosition the engine switch to on Stopping the Engine AC Operation AC Capacity Wattage Reference Table Power Management DC OperationOperation Disconnecting the Battery Charging Cable Smart Throttle SystemStandby Power Connections to a Building Electrical SystemParallel operation procedure Parallel Generator OperationShutting off the generators High Altitude Use Carburetor ModificationSource of Emissions Emission Control System InformationAlterations Problems Affecting Emissions Replacement PartsMaintenance Importance of MaintenanceMaintenance Safety Safety PrecautionsPeriodic Maintenance Periodic Maintenance ChartOpening the Service Door Initial Maintenance Fuel SystemHour Initial Break-In Fuel Line InspectionOFF Oil Recommendation Engine OilOil Level Inspection Oil Change Procedure Maintenance Air Filters Air Filter InspectionAir Filter Cleaning Air Filter ReplacementSpark Plug Inspection and Replacement Spark PlugGap should be 0.6 0.7 mm Transportation Transportation and StorageTransporting the Generator Storage Storage PreparationAccessing the Fuel Tank Draining Fuel from the Fuel Tank and Carburetor Fogging the Engine Storage Precautions Removing from StorageSpecifications General SpecificationsPolaris Lubricants and Maintenance Products Modified coefficient table of ambient condition powerWiring Diagrams P1000i Wiring DiagramP2000i Wiring Diagram Red Gray Brown White BlackTroubleshooting Troubleshooting SymptomsEngine Will Not Turn Over Engine Turns Over, but Will Not StartEngine Lacks Power Engine BackfiresEngine Pings or Knocks Engine Runs Irregularly, Stalls, or MisfiresNo Power at DC Receptacle Possible Lean Solution Fuel CauseNo Power at AC Receptacles Engine Stops or Loses PowerWarranty About this Warranty Document Warranty Registration FormWarranty Period Warranty Exclusions Polaris Power Generator Owner Responsibility Important Notice Maintenance LOG DATE/HOURS Service Comments Supplier Permormed TechnicianIndex Label LocationIndex PMS