Polaris P2000i, P1000i manual Shutting off the generators

Page 40

OPERATION

Parallel Generator Operation

Parallel operation procedure

While operating in parallel, the only AC output is through the receptacle on the parallel cable box.

Do not use the receptacles on the control panel of the generator.

The required output of the electrical appliance cannot exceed the rated output of parallel generators.

Shutting off the generators

1.Turn off the power of electrical appliance then, pull out the receptacle plug.

2.Turn off the two generators.

3.Disconnect the parallel kits from the generators.

The parallel cable connectors can only be used with POLARIS parallel ready generators.

While connecting the generator and electrical appliance with the parallel output cable, do so carefully and safely insert the plug into the receptacle.

While operating in parallel, the only AC output is through the receptacle on the parallel cable box. Do not use the receptacles on the control panel of either generator.

Do not disconnect the parallel cables during operation

39

Image 40
Contents Polaris Power Table of Contents Introduction WelcomeIntended Use Safety Precautions Signal Words and Safety Terms Alcohol or Drug USEIdentification Numbers and Locations P1000iP2000iSafety Safety Warnings and PrecautionsGeneral Before and During OperationFire Safety Operator Safety Fuel Safety Carbon Monoxide Safety Electrical Safety Extension Cord Information Equipment ModificationsSafety Labels and Locations Carbon Monoxide WarningOutdoor Use only Danger Label Hot Exhaust CautionSafety Controls and Features Generator ComponentsControl Panel Components P1000i P2000iEngine Fuel Switch Choke LeverFuel Tank Cap Vent Lever Starter Recoil GripSmart Throttle Switch DC Receptacle and FuseGround Terminal Indicator PanelAC Receptacles Overload Protector Reset Switch Parallel ReceptaclesFirst USE Instructions Adding Engine OilFuel Recommendation Adding Fuel Pre-Operation Checklist PRE-OPERATION InspectionSafe Operating Precautions OperationFuel Recommendations RefuelingRemove the fuel tank cap a Before Starting the Engine Starting the EnginePosition the engine switch to on Stopping the Engine AC Operation AC Capacity Wattage Reference Table Power Management DC OperationOperation Disconnecting the Battery Charging Cable Smart Throttle SystemStandby Power Connections to a Building Electrical SystemParallel operation procedure Parallel Generator OperationShutting off the generators High Altitude Use Carburetor ModificationSource of Emissions Emission Control System InformationAlterations Problems Affecting Emissions Replacement PartsMaintenance Importance of MaintenanceMaintenance Safety Safety PrecautionsPeriodic Maintenance Periodic Maintenance ChartOpening the Service Door Initial Maintenance Fuel SystemHour Initial Break-In Fuel Line InspectionOFF Oil Recommendation Engine OilOil Level Inspection Oil Change Procedure Maintenance Air Filters Air Filter InspectionAir Filter Cleaning Air Filter ReplacementSpark Plug Inspection and Replacement Spark PlugGap should be 0.6 0.7 mm Transportation Transportation and StorageTransporting the Generator Storage Storage PreparationAccessing the Fuel Tank Draining Fuel from the Fuel Tank and Carburetor Fogging the Engine Storage Precautions Removing from StorageSpecifications General SpecificationsPolaris Lubricants and Maintenance Products Modified coefficient table of ambient condition powerWiring Diagrams P1000i Wiring DiagramP2000i Wiring Diagram Red Gray Brown White BlackTroubleshooting Troubleshooting SymptomsEngine Will Not Turn Over Engine Turns Over, but Will Not StartEngine Lacks Power Engine BackfiresEngine Pings or Knocks Engine Runs Irregularly, Stalls, or MisfiresNo Power at DC Receptacle Possible Lean Solution Fuel CauseNo Power at AC Receptacles Engine Stops or Loses PowerWarranty About this Warranty Document Warranty Registration FormWarranty Period Warranty Exclusions Polaris Power Generator Owner Responsibility Important Notice Maintenance LOG DATE/HOURS Service Comments Supplier Permormed TechnicianIndex Label LocationIndex PMS