Agilent Technologies 1690 manual Set up the 1680A,AD-series logic analyzer, Channel Define meas

Chapter 3: Testing Performance

To set up the test equipment and the logic analyzer

bConfigure the oscilloscope according to the following table.

Oscilloscope Setup

Acquisition	Display	Trigger	[Shift] ∆ Time
Averaging: On	Graticule graphs: 2	Level: 0.0 V	Stop src: channel 2 [Enter]
# of averages: 16
Channel 1	Channel 2		Define meas
External Scale	External Scale		Thresholds: user-defined
Attenuation: 20.00:1	Attenuation: 20.00:1		Units: Volts
Scale: 200 mV/div	Scale: 200 mV/div		Upper: - 980 mV
Offset: - 1.300 V	Offset: - 1.300 V		Middle: -1.30 V
			Lower: -1.62 V

Set up the 1680A,AD-series logic analyzer

Power-up self tests are done on the logic analyzer system components when power is applied. Any problems reported by the logic analyzer during boot must be cleared before going further. For more information, refer to Chapter 5 and Chapter 8.

1Turn on the logic analyzer:

a Connect a keyboard and mouse to the rear panel of the logic analyzer.

b Plug in a power cord to the rear panel power connector of the logic analyzer.

c Turn on the power switch on the logic analyzer front panel.

2Set up the logic analyzer:

a Wait for the logic analyzer boot up to complete.

b On the logic analyzer desktop, double-click the Agilent Logic Analyzer icon to launch the application.

24