Chapter 3: Testing Performance
To test the single-clock, single-edge, state acquisition
cClick the Master buttons for the remaining clocks and select Don't Care to turn off the other clocks.
dConnect the clock to be tested to the pulse generator channel 1 output.
eClick OK to close the Analyzer Setup dialog.
5Verify the test data:
a Click the 
Run icon.
b If you have not already done so, do “Set up the Markers:” on page 34.
c If the "can't find 4096 occurence(s)" message does not appear, the test passes.
The test passes when the logic analyzer finds all occurances of the patterns programmed into the Markers. If the test passes, record a "Pass" in the performance test record under
6Test the next clock:
a Click on the 
Sampling Setup icon.
b Disconnect the clock just tested from the pulse generator.
c Repeat steps 4, 5, and 6 for the next clock configuration listed in step 4 until all listed clock combinations have been tested.
7Enable the pulse generator channel 1 COMP (with the LED on).
8Using the Delay mode of the pulse generator channel 1, position the pulses according to the setup/hold combination selected, +0.0 ps or
a On the Oscilloscope, select [Define meas] Define ∆ Time - Stop edge: falling.
b On the oscilloscope, select [Shift] ∆ Time. Select Start src: channel 1,
44