PROBLEM OR CONCERN | POSSIBLE CAUSE | SOLUTION |
|
|
|
Gun/Hose - Leaking water |
| Gun/Hose will need to be replaced. Replace- |
|
| ment parts are not available for the Gun/Hose. |
|
| Email us at customerservice@huskypow |
|
| erwasher.com for assistance or order onli- |
|
| ne at www.huskypowerwasher.com. |
Leaking Oil from Pump |
| A small amount of leakage is normal. If leakage |
|
| occurs please contact use directly at customerser |
|
| vice@huskypowerwasher.com. |
Leaking water from bottom | Machine Inlet connection is de- | Check the Machine Inlet at the front of the unit to |
of unit | fective | ensure that water is not leaking from it. If the con- |
|
| nection is leaking it will have to be replaced. |
|
| Contact us at customerservice@huskypo |
|
| werwasher.com or order a replacement |
|
| directly online at www.huskypowe- |
|
| rwasher.com . |
| Pump housing is leaking water | Email us at customerservice@huskypow |
|
| erwasher.com for assistance. |
Low pressure | Faucet not fully open or unit is not | Open the faucet all the way. |
| receiving a full volume of water |
|
Not building maximum Pres- | Screen Filter is clogged | Clean the Screen filter as instructed in the section 5.4. |
sure |
|
|
Irregular Pressure | Gun or Hose failure | Replace Gun and/or Hose. Contact us at custome |
|
| rservice@huskypowerwasher.com ororder |
|
| online at www.huskypowerwasher.com. |
| Kink in the Garden Hose or Hose | Unwrap the Garden Hose and lay it out flat to |
| is wrapped on a storage wheel | ensure that there are no kinks in the Hose. |
| Water leaking from either Hose | Stop water from leaking before using the unit |
| or Unit | or contact us if you need assistance. |
| Garden Hose length is too long | Shorten the length of the Garden Hose. We recom- |
|
| mend a maximum length of 25 to 50 feet for City |
|
| water supply and 30 feet for Well water supply. |
| Clogged Nozzle | Clean the Nozzle as instructed in section 5.2. |
| Air in Pump | Let Pressure washer run with Gun trigger de- |
|
| pressed and Wand removed until a steady |
|
| stream of water is released. |
| No Wand attached to the front | Attach either the Turbo or Adjustable Wand to |
| of the Gun | the front of the Gun. (High Pressure is created |
|
| with the Wand and not the Gun). |
No water coming out of Wand | Clogged Nozzle | Clean Nozzle as instructed in section 5.2. |
| Quick Connect is attached in- | See section 3.2. To Attach Quick Connect pro- |
| correctly | perly, keep the outer collar of the Quick Con- |
|
| nect held back while sliding the Quick Connect |
|
| all the way forward against the Inlet Nipple |
|
| and then release the collar to lock it into place. |
|
| (The collar is spring loaded so if it is released |
|
| too soon it will not lock into place). |
| Sceen Filter is clogged | Clean the Sceen filter as instructed in section 5.4. |
24