Husky 1800 CA manual Werwasher.com

PROBLEM OR CONCERN	POSSIBLE CAUSE	SOLUTION
	Wand is malfunctioning	Test both wands to ensure that one is not mal-
		functioning.
	Gun is not operating properly	Remove Wand from the Gun and squeeze trigger to
		ensure that the water is coming out of the front of the
		Gun at a rate equal to the Garden Hose.
Wand - Attaching		To attach the Wand apply some moderate
		downward pressure on the Wand (In the direc-
		tion of the trigger) while simultaneously twisting
		the wand a 1/4 of a turn clockwise. It may help
		if you set the gun vertically on a flat surface with
		the wand pointing upwards. The two tabs on the
		end of the Wand must slide all the way in before
		the Wand will twist and lock. If this does not work
		remove the o-ring from the end of the wand and
		attach it without the o-ring. If the wand attaches,
		you will need to replace the o-ring. Contact us at
		customerservice@huskypowerwasher.
		com or order a replacement directly online at
		www.huskypowerwasher.com.
Wand - Removing		Release the back pressure in the Gun/Hose. Re-
		move the Garden Hose from the unit and squee-
		ze the trigger of the Gun. Apply some moderate
		downward pressure on the Wand (In the direc-
		tion of the trigger) while simultaneously twisting
		the wand a 1/4 of a turn counterclockwise. (It
		may help if you set the gun vertically on a flat
		surface with the Wand pointing upwards). For
		additional assistance you can email us at custo
		merservice@huskypowerwasher.com.
Wand - Gray collar won’t		To turn the gray collar, hold the Wand hori-
turn/won’t adjust to low/		zontally in both hands. Hold the collar firmly
high pressure		in one hand and the shaft of the Wand in the
		other hand. It works best if you grab the shaft
		by the “beehive” shaped portion at the bottom
		of the Wand. Sometimes the gray collar gets
		tightened down too far and needs some extra
		force to move it. For additional assistance you
		can email us at customerservice@huskypo
		werwasher.com.

26