PROBLEM OR CONCERN | POSSIBLE CAUSE | SOLUTION |
|
|
|
| Kink in the Garden Hose or Hose | Unwrap the Garden Hose and lay it out flat to |
| is wrapped on a storage wheel | ensure that there are no kinks in the Hose. |
| Detergent Suction Assembly (the | Remove the Gun and Hose assembly from the front of |
| part which the High Pressure | the unit. Aim water stream away from electric sour- |
| Hose connects to) is defective | ce. Turn the faucet on. Water should start to come |
|
| out of the front of the unit. If no water comes out, the |
|
| Detergent Suction Assembly will have to be replaced. |
|
| Contact us at customerservice@huskypower |
|
| washer.com or order a replacement directly onli- |
|
| ne at www.huskypowerwasher.com. |
| Gun/Hose Assembly is defec- | Attach the Gun/Hose to the front of the unit with no |
| tive | wand attached to the Gun. Squeeze the trigger of |
|
| the gun to ensure that water comes out of the front |
|
| of the Gun at a rate equal to the Garden Hose. If no |
|
| water comes out of the Gun it will have to be repla- |
|
| ced. Contact us at customerservice@huskypo |
|
| werwasher.com or order a replacement directly |
|
| online at www.huskypowerwasher.com. |
Trigger will not move | Gun Safety Lock is engaged | Release Safety Lock as instructed in Manual. |
|
|
|
Unit will not start | Unit is not turned on | Press ON/OFF Switch into ON position. |
Note: Unit will only start when |
|
|
Loose or disconnected Plug | Reconnect Plug. | |
trigger is depressed. |
|
|
Unit stops while operating | Defective GFCI Plug | Perform GFCI reset procedure as instructed in |
| Section 2.0. If the Plug does not reset it will | |
|
| need to be replaced. Contact us at custome |
|
| rservice@huskypowerwasher.com or |
|
| order a replacement directly online at www. |
|
| huskypowerwasher.com. |
| Extension Cord length or gauge | Use proper Extension Cord as instructed in section |
| incorrect | 2.0. |
| Gun trigger not operating pro- | Contact us at customerservice@huskypow |
| perly | erwasher.com or order a replacement directly |
|
| online at www.huskypowerwasher.com. |
| Defective Gun | Remove the Gun and Hose assembly from the front |
|
| of the unit. Aim water stream away from electric |
|
| source and switch the unit into the ON position. |
|
| If the unit starts and water comes out of the front, |
|
| the Gun may need to be replaced. Contact us at |
|
| customerservice@huskypowerwasher. |
|
| com or order a replacement directly online at |
|
| www.huskypowerwasher.com. |
| Tripped Pressure washer Ther- | Allow to cool and restart unit. |
| mal Switch |
|
| Defective ON/OFF Switch | Contact us at customerservice@huskypow |
|
| erwasher.com or order a replacement directly |
|
| online at www.huskypowerwasher.com. |
Unit will not stop when trig- | Screen filter is clogged | Clean the Screen filter as instructed in section |
ger is released |
| 5.4. |
| Garden Hose is kinked or | Make sure the Garden Hose is laid out flat and |
| leaking water | there are no kinks in it. The hose should not be |
|
| wrapped on a storage wheel. Make sure the |
|
| faucet is open all the way and there is a full |
|
| volume of water reaching the unit. |
25