Craftsman 580.6722 Pressure Washer Rinsing, To apply detergent, follow these steps, For Rinsing

To apply detergent, follow these steps:
1	Review	use of adjustable nozzle.
2	Prepare	detergent solution	as required	by job
.	Place filter end of detergent		siphoning	tube into
	detergent container.

CAUTION

•When insertingthe filter into a detergent solution bottle, route the tube so as to keep it from inadvertently contacting the hot muffler.

4.Slide adjustable nozzle forward to low pressure mode. Detergent cannot be applied with nozzle in high pressure position.

5.Make sure garden hose is connected to water inlet. Check that high pressure hose is connected to spray gun and pump. Start engine.

6.Apply detergent to a dry surface, starting from bottom and working up.

7.Allow detergent to "soak in" for 3-5 minutes before rinsing. Reapply as needed to prevent surface from drying.

8.For washing, start at lower portion of area to be washed and work upward, using long, even, overlapping strokes.

IMPORTANT: You must flush the chemical injection system after each use by placing the filter into a clean

bucket of water and running the pressure washer in low pressure for 1-2 minutes.

Pressure Washer Rinsing

For Rinsing:

1Slide nozzle backward to high pressure, press trigger and wait for detergent to clear.

NOTE: You can also stop detergent flow by removing detergent siphoning tube from container.

2.Keep spray gun a safe distance from area you plan to spray.

WARNING

Keep spray nozzle between 8 to 24 inches away from cleaning surface.

Operate this unit on a stable surface.

Be extremely careful if you must use the pressure washer from a ladder, scaffolding or any other relatively unstable location.

Firmly grasp spray gun with both hands when using high pressure spray to avoid injury if gun kicks back.

. Apply a high pressure spray to a small area, then check surface for damage, if no damage is found, it is okay to continue cleaning.

4.Start at top of area to be rinsed, working down with same overlapping strokes as you used for washing and applying detergent.

Automatic Cool Down System

(Thermal Relief)

If you run the engine on your pressure washer for

3-5 minutes without pressing the trigger on the spray gun, circulating water in the pump can reach temperatures above 125°F (51°C). The system engages to cool the pump by discharging the warm water onto the ground

10