6.PourslowlyWipedipstickcleaneachtimeoil.
levelischeckedDONOToverfill..
7.Installoilfill pluganddipstick,tightensecurely.
Add Fuel
,_ WARNING!NEVER fill fuelNEVERtank whenfill fuelenginetank indoorsis running or hot. DO NOT smoke when filling fuel tank.
_ WARNING! NEVER fill fuel tank completely full. Provide space for fuel expansion. Wipe
away any fuel spillage from engine and equipment before starting.
1.Use clean regular unleaded automotive fuel and store in approved, clean, covered containers. Use clean fill funnels. NEVER use "stale" fuel left over
from last season or fuel stored for long periods.
2.Clean area around fuel fill cap, remove cap.
3.Slowly add fuel to fuel tank. Use a funnel to prevent spillage. Fill tank to about 1.5" below the top of the filler neck.
Fuel
4.Install fuel cap and wipe up any spilled fuel
IMPORTANT: It is important to prevent gum deposits from forming in essential fuel system parts, such as the carburetor, fuel filter, fuel hose or tank during storage. Also, experience indicates that
To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. See "Storage" on page 15. NEVER use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.
Connect Hose and Water Supply to Pump
IMPORTANT: To avoid pump damage, you must assemble the nozzle extension to the spray gun and attach all hoses before you start the engine.
1.Uncoil high pressure hose and attach one end of hose to base of spray gun. Tighten by hand.
2.Attach other end of high pressure hose to high pressure outlet on pump. Tighten by hand.
,Before connecting garden hose to water inlet, inspect inlet screen. Clean screen if it contains debris or have it replaced if damaged. Refer to section
screen. DO
NOT use if
"_._Inspect inlet damaged;
- clean if dirty.
4, Run water through garden hose for 30 seconds to flush out any debris.
5, Connect garden hose (not to exceed 50 feet in length) to water inlet. Tighten by hand.
CAUTION
•Damage to equipment resulting from failure to fellow this instruction will void warranty,
6, Turn ON water and squeeze trigger on gun to purge pump system of air and impurities.
WARNING
Always wear eye protection when using this equipment or in vicinity of where equipment is in use,
Before starting the pressure washer, be sure you are wearing adequate eye protection,
CHECKLIST BEFORE STARTING ENGINE
Review the unit to ensure you have performed all of
the following:
1Check that oil has been added to proper level in engine crankcase
2Add proper fuel to fuel tank.
3.Check for properly tightened hose connections (high pressure and water supply) and there are no kinks, cuts, or damage to high pressure hose
7