Generac Portable Products 1900 PSI Pressure Washer
TROUBLESHOOTING
Problem | Cause | Correction | |||
| 1. | Nozzle in low pressure mode. | 1. | Pull nozzle backward for high | |
|
|
|
| pressure mode. | |
| 2. | Water inlet is blocked. | 2. | Clear inlet. | |
| 3. | Inadequate water supply. | 3. | Provide adequate water flow. | |
| 4. | Inlet hose is kinked or leaking. | 4. | Straighten inlet hose, patch leak. | |
Pump has following problems: | 5. | Clogged inlet hose strainer. | 5. | Check and clean inlet hose | |
|
|
| strainer. | ||
failure to produce pressure, |
|
|
| ||
|
|
|
| ||
erratic pressure, chattering, loss | 6. | Water supply is over 100°F. | 6. | Provide cooler water supply. | |
of pressure, low water volume. | 7. | High pressure hose is blocked or | 7. | Clear blocks in outlet hose. | |
| |||||
|
| leaks. |
|
| |
| 8. | Gun leaks. | 8. | Replace gun. | |
| 9. | Nozzle is obstructed. | 9. | Clean nozzle. | |
| 10.Pump is faulty. | 10.Contact Briggs & Stratton Power | |||
|
|
|
| Products service facility. | |
|
|
|
|
| |
| 1. | Detergent siphoning tube is not | 1. | Insert detergent siphoning tube | |
|
| submerged. |
| into detergent. | |
| 2. | Chemical filter is clogged. | 2. | Clean or replace filter/detergent | |
Detergent fails to mix with spray. |
|
|
| siphoning tube. | |
3. | Dirty | 3. | See "Check | ||
| |||||
| 4. | Nozzle is in high pressure mode. | 4. | Push nozzle forward for low | |
|
|
|
| pressure mode. | |
|
|
|
|
| |
Engine runs good at |
| Engine speed is too slow. |
| Move throttle control to FAST | |
|
|
| position. If engine still "bogs down", | ||
"bogs" when load is added. |
|
|
| ||
|
|
| contact engine manufacturer. | ||
|
|
|
| ||
|
|
|
|
| |
Engine shuts down during |
| Out of gasoline. |
| Fill fuel tank. | |
operation. |
|
|
|
| |
|
|
|
|
|
15