Briggs & Stratton 1900PSI owner manual HOW to USE Pressure Washer, How To Start Pressure Washer

Page 8

Generac Portable Products 1900 PSI Pressure Washer

HOW TO USE PRESSURE WASHER

If you have any problems operating your pressure washer, please call the pressure washer helpline at

1-800-270-1408.

How To Start Pressure Washer

To start your pressure washer for the first time, follow these instructions step-by-step.This starting information also applies if you have let the pressure washer sit idle for at least a day.

1.Place pressure washer near an outside water source capable of supplying water at a flow rate greater than 3.0 gallons per minute and no less than 20 PSI at pressure washer end of garden hose.

2.Check that high pressure hose is tightly connected to spray gun and to pump. See “Preparing Pressure Washer for Use” for illustrations.

3.Make sure unit is in level position.

4.Connect garden hose to water inlet on pressure washer pump. Turn ON the water.

CAUTION

DO NOT run the pump without the water supply connected and turned on.

•Damage to equipment resulting from failure to follow this instruction will void warranty.

6.Position nozzle in low pressure mode (see “How To Use Adjustable Nozzle”) and squeeze trigger on spray gun to relieve air pressure caused by turning ON water.Water will flow out of spray gun in thin stream. Continue to hold trigger until steady stream of water occurs and no air remains in system.This will make it easier to pull start the engine. Release trigger.

7.Engage safety latch to spray gun trigger (Figure 5).

Figure 5 — Spray Gun with Safety Latch Engaged

Safety Latch

8.Start engine according to instructions given in engine owner’s manual.

CAUTION

Avoid injury from kickback.

•Squeeze trigger on spray gun each time recoil starter is pulled and engine fails to start.

CAUTION

Avoid fire from equipment tip over.

•Always use handle to lift equipment.

•NEVER pull on hoses to move equipment.

NOTE: Always keep the throttle lever in the “Fast”

5. Attach adjustable nozzle extension to spray gun	position when operating the pressure washer.
(Figure 4).Tighten by hand.

Figure 4 — Connect Nozzle Extension to Spray Gun

How To Stop Pressure Washer

•Turn engine off according to instructions given in the engine owner’s manual.

•Squeeze trigger on the spray gun to relieve pressure in the hose.

NOTE: A small amount of water will squirt out when pressure is released.

8

Image 8

Contents 1900PSI Equipment Description Table of ContentsSafety Rules When Transporting or Repairing Equipment High pressure spray may damage fragile items including glass Know Your Pressure Washer Assembly Carton ContentsPreparing Pressure Washer for USE Remove Pressure Washer From CartonChecklist Before Starting Engine Connect Hose and Water Supply to PumpHow To Stop Pressure Washer HOW to USE Pressure WasherHow To Start Pressure Washer How To Use Adjustable Nozzle Applying Detergent With Adjustable NozzleImportant Use soaps designed specifically for To apply detergent, follow these stepsPressure Washer Rinsing Automatic Cool Down SystemThermal Relief For RinsingPressure Washer Maintenance SpecificationsGeneral Maintenance Recommendations Check In-Line Filter Cleaning Chemical Injection HoseNozzle Maintenance Engine Maintenance Ring MaintenancePump Maintenance Change pump oil as followsProtecting the Pump Preparing the Unit for StorageStoring the Engine Troubleshooting Items Not Illustrated Exploded View and Parts List Main UnitDescription Exploded View and Parts List Pump Generac Portable Products 1900 PSI Pressure Washer About your equipment warranty Effective January 1Tabla DE Contenidos Descripción DEL EquipoReglas DE Seguridad AdvertenciaPeligro Cuando Añada CombustiblePrecaución Conozca SU Maquina Lavadora DE Presion Montaje Preparando EL Lavador a Presión Para SU USORemueva el Lavador a Presión del Empaque Contenido de la CajaConecte Manguera y Suministro de Agua a Bomba Lista de Revision Previa al Arranque MotorCómo Detener su Máquina Lavadora a Presión Cómo Usar SU Máquina Lavadora a PresiónCómo Darle Arranque a su Máquina Lavadora a Presión Para aplicar el detergente, siga los siguientes pasos Cómo Usar la Boquilla AjustableAplicación del Detergente Usando la Boquilla Ajustable Para Enjuage Enjuage de la Máquina Lavadora a PresiónSistema de Enfriamiento Automático Alivio Térmico Mantenimiento DE LA Maquina Lavadora a Presion EspecificacionesRecomendaciones Generales Revise el Filtro en Línea Limpiando el TuboMantenimiento de las Boquillas BoquillaMantenimiento DEL Motor Mantenimiento de los Anillos OMantenimiento de la Bomba Cambio del aceite de la bombaProteger la Bomba Preparando LA Unidad Para SU AlmacenamientoAlmacenando EL Motor Notas Reparacion DE Averias Efectiva desde el 1ro de Enero Lavador de presiónGenerador portátil Acerca de la seguridad de su equipoSymboles de Danger et Moyens Table DES MatièresDescription DE L Équipement Règles DE SécuritéLorsque Vous Ajoutez DU Carburant Unintentional peut résulter dans feu ou électrique Connaître Votre Pulvérisateur À Pression Assemblage Préparer Votre Pulvérisateur Pour LutilisationDéballer le Pulvérisateur du Carton Contenu du CartonRaccorder le Tuyau et la Source Deau à la Pompe Liste de Vérifications Avant de Démarrer le MoteurComment Arrêter Votre Pulvérisateur Comment Utiliser Votre PulvérisateurMettre Votre Pulvérisateur en Marche Pour appliquer des produits détergents, procédez comme suit Comment Utiliser les Gicleurs RéglablesAppliquer des Produits Détergents avec le Gicleur Réglable Rincer le Pulvérisateur Pour rincerEntretien DU Pulvérisateur Recommandations Dentretien GénéralCaractéristiques Vérifier le Filtre Intégré Entretien du GicleurNettoyer le Tube Siphon des Produits Détergents Pour purger les impuretés de la pompe, procédez comme suitEntretien DU Moteur Entretien du Joint ToriqueEntretien de la Pompe Vidange de lhuileProtection de la Pompe Préparer Lappareil Pour LentreposageRanger LE Moteur Dépannage Remarques Remarques En vigueur à partir du 1er Janvier Propos de la garantie de votre équipement