Generac Portable Products 1900 PSI Pressure Washer
CAUTION
Keep the chemical injection tube from coming in contact with the hot muffler.
•When inserting the filter into a detergent solution bottle, route the tube so as to keep it from inadvertently contacting the hot muffler.
4.Slide adjustable nozzle forward to low pressure mode. Detergent cannot be applied with nozzle in high pressure position.
5.Make sure garden hose is connected to water inlet. Check that high pressure hose is connected to spray gun and pump; start engine.
6.Apply detergent to a dry surface, starting at lower portion of area to be washed and work upward, using long, even, overlapping strokes.
7.Allow detergent to "soak in" for
IMPORTANT: You must flush the chemical injection system after each use by placing the filter into a bucket of clean water, then run the pressure washer in low pressure for
Pressure Washer Rinsing
For Rinsing:
1.Slide nozzle backward to high pressure, press trigger and wait for detergent to clear.
NOTE: You can also stop detergent from flowing by simply removing chemical injection hose from bottle.
2. Keep spray gun a safe distance from surface.
3.Apply high pressure spray to a small area, then check surface for damage. If no damage is found, it is okay to continue cleaning.
WARNING
High pressure spray could cause you to fall if you are too close to the cleaning surface.
•Keep spray nozzle between 8 to 24 inches away from cleaning surface.
•Operate this unit on a stable surface.
•Be extremely careful if you must use the pressure washer from a ladder, scaffolding or any other relatively unstable location.
•Firmly grasp spray gun with both hands when using high pressure spray to avoid injury if gun kicks back.
4.Start at top of area to be rinsed, working down with same overlapping strokes as used for washing and applying detergent.
Automatic Cool Down System
(Thermal Relief)
If you run the engine on your pressure washer for
discharging the warm water onto the ground.
10