Pentair PowerMax For Your Safety Read Before Lighting, Operating Instructions, Safety Lockout

Page 6
Safety Lockout:

Operation (contd.)

6

 

 

MINIMAX PLUS ELECTRONIC IGNITION LIGHTING/OPERATION - PROPANE

FOR YOUR SAFETY: READ BEFORE LIGHTING

NOTE

The MiniMax Plus propane models have special features for additional safety and protection. Read the safety instructions for natural gas (page 5) before proceeding.

Manual backgroundWARNING

If you do not follow these instructions exactly, a fire or explosion may result causing personal injury, loss of life and property damage.

Since propane gas is heavier than air, escaping propane will accumulate and remain at ground level. Do not attempt to light the heater. If you suspect a propane leak, lighting the heater can result in a fire or explosion which can cause personal injury, death, and property damage.

WHAT TO DO IF YOU SMELL GAS

-Do not try to light matches or lighter.

-Do not try to light any heater.

-Do not touch any electrical switch; do not use any phone in your building.

-Shut off gas line at propane tank.

Safety Lockout:

-Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.

-If you cannot reach your gas supplier, call the Fire Department.

-Do not tamper with the heater because it is dangerous and voids all warranties.

This MiniMax Plus Propane Heater is equipped with a 100% safety lockout feature. If the pilot does not light within a maximum of 90 seconds, lockout will occur.

OPERATING INSTRUCTIONS

1.STOP! Read the safety information above.

2.Set the thermostat to the lowest setting.

3.Turn off electric power to the heater.

4.This heater is equipped with an ignition device which automatically lights the pilot. Do not try to light the pilot by hand.

5.Remove the control access door.

6.Push in gas control knob slightly and turn clock-

wise Manual background to “OFF”.

7.Wait five (5) minutes to clear out any gas. If you then smell gas, STOP! Follow "B" in the safety information on page 5. If you don't smell gas, go to the next step.

8.Turn knob on gas control counterclockwise Manual background to “ON”; see Figure 2.

9. Replace the control access door.

10.Turn on the electrical power to the heater.

11.Set the thermostat to the desired setting.

12.If the heater will not operate, follow the instruc- tions "To Turn Off Gas To Heater" and call your service technician or gas supplier.

Gas

Inlet

ON

OFF

Figure 2. Gas control knob shown in “ON” position.

TO TURN OFF GAS TO APPLIANCE

1.Set the thermostat to lowest setting.

2.Turn off all electric power to the heater if service is to be performed.

3.Remove control access door.

4.Push in gas control knob slightly and turn

clockwise Manual background to "OFF". Do not force.

5.Replace control access door.

P/N 471048

Rev. G 1-22-04

Image 6
Contents For Your Safety MiniMax Plus and PowerMaxOPERATION & INSTALLATION MANUAL FOR YOUR SAFETY - READ BEFORE OPERATINGTable of Contents CODE REQUIREMENTS IntroductionPool and Spa Heaters IMPORTANT NOTICESWARRANTY INFORMATION SAFETY RULESOperation TO TURN OFF GAS TO APPLIANCE FOR YOUR SAFETY READ BEFORE LIGHTINGOPERATING INSTRUCTIONS WHAT TO DO IF YOU SMELL GASSafety Lockout LIGHTING INSTRUCTIONS WHAT TO DO IF YOU SMELL GASGas control knobs shown in “OFF” position THERMOSTAT ADJUSTMENT INDICATOR LIGHT DESCRIPTIONOPERATING CONTROLS POWER THERMOSTAT SELECT SWITCHTROUBLESHOOTING CONTROLS SERVICE SERVICEHEAT HEAT TROUBLESHOOTING CONTROLS - Continued HEATER FIRING - NORMAL OPERATIONIS IN THERMAL FUSE CIRCUIT ENERGY SAVING TIPS MaintenanceMAINTENANCE INSTRUCTIONS SPRING AND FALL OPERATIONpH Control Chart CHEMICAL BALANCEpH Chart POOL AND SPA WATEROutdoor installation - stackless Installation InstructionsSPECIFICATIONS Outdoor installation - with vent kitPLUMBING CONNECTIONS WATER CONNECTIONSPLUMBING BELOW POOL INSTALLATIONQUICK-FLANGEINSTALLATION INSTRUCTIONS A manual main shut-offvalve must be installed GAS CONNECTIONSGAS LINE INSTALLATIONS externally to the heaterOUTDOOR VENT CAP INSTALLATION VENTILATIONOUTDOOR INSTALLATION ONLY STACK TYPE OUTDOOR VENT KIT24 in FrontWater Connection RemainingMiniMax heaters, including PowerMax versions STACK TYPE INDOOR DRAFT HOOD KITAir supply requirements below apply to all ELECTRICAL, IID ELECTRONIC UNITS INDOOR DRAFT HOOD INSTALLATIONTransformer Wiring Instruction Draft Hood Top Cover Adaptor Screw 2 PLCs HEATERIgnition Wiring Diagram MiniMax Plus WIRING DIAGRAMMiniMax Plus Electronic 3 Wire Remote MiniMax Plus Millivolt Wiring DiagramREMOTE SWITCH DUAL THERM IID ONLY 2 Wire RemoteTroubleshooting - General Model No MINIMAX PLUS HEATER - ALL MODELSINNER TOPS 470024MiniMax Plus Only Parts List DESCRIPTION195/200 195/200 MiniMax Plus Only Parts List, contdDESCRIPTION Not ShownINSTALLER AFFIX THESE INSTRUCTIONS PowerMax Pool & Spa HeaterOPERATION & INSTALLATION MANUAL APPENDIXPowerMax Pool and Spa HeaterDESCRIPTION OF SYSTEM OPERATION MOUNTING ASSEMBLYPRESSURE SWITCH OPERATION SYSTEM OPERATIONVENTING Reduced Maximum Equivalent Vent Run feetVent termination for side wall installations INDOOR INSTALLATIONS POWERMAX VENTING GUIDELINESVent for roof penetration installations DIAGRAMOUTDOOR INSTALLATION POWERMAX VENTING GUIDELINES The Vent PipeVent Termination POWERMAX WIRING DIAGRAM INSTRUCTION FOR WIRING A POWERMAX INDUCED DRAFT ASSEMBLY TO A POOL HEATER WITH IID IGNITIONWIRING DIAGRAM FOR POWERMAX KIT POWERMAX HEATER - ALL MODELS OPTIONAL OUTDOOR VENTA-10 PowerMax Heater Only Parts List DESCRIPTION195/200 PowerMax Heater Only Parts List, contd DESCRIPTIONNot Shown PowerMax Assembly Parts List PowerMax AssemblyDESCRIPTION SAVE THESE INSTRUCTIONS Pentair Pool Products, Inc