Genie 114002 manual Maintenance, Observe and Obey, Check the Battery DC Models

Page 14

Operator’s Manual

Third Edition • First Printing

 

 

 

 

Maintenance

Observe and Obey:

Only routine maintenance items specified in this manual shall be performed by the operator.

Scheduled maintenance inspections shall be completed by qualified service technicians, according to the manufacturer's specifications and the requirements specified in the responsibilities manual.

Maintenance Symbols Legend

The following symbols have been used in this manual to help communicate the intent of the instructions. When one or more of the symbols appear at the beginning of a maintenance procedure, it conveys the meaning below.

Indicates that tools will be required to perform this procedure.

Indicates that new parts will be required to perform this procedure.

Check the Battery - DC Models

Proper battery condition is essential to good machine performance and safe operation. Improper fluid levels or damaged cables and connections can result in component damage and hazardous conditions.

Electrocution hazard. Contact with hot or live circuits could result in death or serious injury. Remove all rings, watches and other jewelry.

Bodily injury hazard. Batteries contain acid. Avoid spilling or contacting battery acid. Neutralize battery acid spills with baking soda and water.

Perform this test after fully charging the battery.

1Put on protective clothing and eye wear.

2Remove the battery vent caps.

3Check the battery acid level. If needed, replenish with distilled water to the bottom of the battery fill tube. Do not overfill.

4Install the vent caps.

12

Genie AWP Super Series

Part No. 114002

Image 14
Contents Operator’s Manual Contents Contact usSafety Rules Do Not Operate UnlessElectrocution Hazards Tip-over HazardsMaximum allowable side force Fall Hazards Collision HazardsExplosion and Fire Hazard Improper Use HazardBodily Injury Hazard Damaged Machine HazardsLifting Hazard Battery and Charger Safety DC Models Burn HazardsExplosion Hazards Decal Legend AC and DC Models Air Models Platform Controls ControlsGround Controls Page Fundamentals Pre-operation InspectionBreather Cap AC & DC Models Pre-operation Inspection PRE-OPERATION InspectionObserve and Obey MaintenanceCheck the Battery DC Models Check the Hydraulic Oil Level Check the Tire Pressure RT Base ModelsCheck the Air Filter/Regulator Canister Air Models Scheduled MaintenanceCheck the Oil Lubricator Canister Drip Rate Air Models Function Tests Function Tests Setup Test Emergency StopTest Outrigger Interlock Workplace Inspection Workplace InspectionOperating Instructions Manual Lowering Emergency StopPlatform Raise and Lower Auxiliary Platform Lowering AC & DC ModelsTo Charge Battery Battery Charging InstructionsBattery and Charger Instructions Observe and Obey Dry Battery Filling Charging InstructionsLifting Instructions Transport InstructionsTransport Instructions Observe and Obey Loading for Transport Transport InstructionsLoading the Machine With a Crane Securing the MachineWinching the Machine onto a Flatbed Truck Tilt-back Frame Tilt-back Operation InstructionsTilt-back Operation Instructions Observe and obey Lowering the Tilt-back Assembly Tilting Back the MachineStowing the Tilt-back Assembly Returning the Machine to Standing PositionDecals Inspection for Decals with WordsModels with Tilt-back Frame Models without Tilt-back Frame Inspection for Decals with Symbols Models with Tilt-back Frame Models without Tilt-back Frame Specifications Machine SpecificationsSpecifications Genie Scandinavia