Genie 114002 manual Emergency Stop, Platform Raise and Lower, Manual Lowering, Fall Protection

Page 22

Operator’s Manual

Third Edition • First Printing

 

 

 

 

OPERATING INSTRUCTIONS

Emergency Stop

Push in the red Emergency Stop button at the platform controls or at the ground controls to stop the up function.

Platform Raise and Lower

1Pull out the red Emergency Stop button to the on position at the ground controls. Twist to release the red Emergency Stop button at the platform controls.

2Push in the control activate button and rotate the up/down switch in the desired direction of travel.

Manual Lowering

1Activate the manual lowering valve located at the bottom of the

hydraulic cylinder.

Auxiliary Platform Lowering - AC & DC Models

1Turn the key switch to ground control. Pull out the red Emergency Stop button to the on position.

2Activate the auxiliary platform lowering button at the ground controls.

Fall Protection

Personal fall protection equipment (PFPE) is not required when operating this machine. If PFPE is required by job site or employer rules, the following shall apply:

All PFPE must comply with applicable governmental regulations and must be inspected and used in accordance with the manufacturer’s instructions.

After Each Use

1Select a safe storage location—firm, level surface, weather protected, clear of obstruction and traffic.

2Chock the wheels to prevent the machine from rolling.

3Remove the key to secure from unauthorized use.

4DC models: Recharge the battery.

20

Genie AWP Super Series

Part No. 114002

Image 22
Contents Operator’s Manual Contents Contact usSafety Rules Do Not Operate UnlessElectrocution Hazards Tip-over HazardsMaximum allowable side force Fall Hazards Collision HazardsExplosion and Fire Hazard Improper Use HazardBodily Injury Hazard Damaged Machine HazardsExplosion Hazards Battery and Charger Safety DC Models Burn HazardsLifting Hazard Decal Legend Ground Controls ControlsAC and DC Models Air Models Platform Controls Page Breather Cap AC & DC Models Pre-operation InspectionFundamentals Pre-operation Inspection PRE-OPERATION InspectionCheck the Battery DC Models MaintenanceObserve and Obey Check the Hydraulic Oil Level Check the Tire Pressure RT Base ModelsCheck the Oil Lubricator Canister Drip Rate Air Models Scheduled MaintenanceCheck the Air Filter/Regulator Canister Air Models Function Tests Function Tests Setup Test Emergency StopTest Outrigger Interlock Workplace Inspection Workplace InspectionOperating Instructions Manual Lowering Emergency StopPlatform Raise and Lower Auxiliary Platform Lowering AC & DC ModelsTo Charge Battery Battery Charging InstructionsBattery and Charger Instructions Observe and Obey Dry Battery Filling Charging InstructionsTransport Instructions Observe and Obey Transport InstructionsLifting Instructions Loading for Transport Transport InstructionsWinching the Machine onto a Flatbed Truck Securing the MachineLoading the Machine With a Crane Tilt-back Operation Instructions Observe and obey Tilt-back Operation InstructionsTilt-back Frame Lowering the Tilt-back Assembly Tilting Back the MachineStowing the Tilt-back Assembly Returning the Machine to Standing PositionDecals Inspection for Decals with WordsModels with Tilt-back Frame Models without Tilt-back Frame Inspection for Decals with Symbols Models with Tilt-back Frame Models without Tilt-back Frame Specifications Machine SpecificationsSpecifications Genie Scandinavia