Genie 114002 manual Workplace Inspection

Page 20

Operator’s Manual

Third Edition • First Printing

 

 

 

 

Workplace Inspection

Do Not Operate Unless:

You learn and practice the principles of safe machine operation contained in this operator’s manual.

1 Avoid hazardous situations.

2 Always perform a pre-operation inspection.

3 Always perform function tests prior to use.

4 Inspect the workplace.

Know and understand the work place inspection before going on to the next section.

5 Only use the machine as it was intended.

Workplace Inspection

Be aware of and avoid the following hazardous situations:

·drop-offs or holes

·bumps, floor obstructions or debris

·slopes that exceed the machine’s leveling capability

·unstable or slippery surfaces

·overhead obstructions and high voltage conductors

·hazardous locations

·inadequate surface support to withstand all load forces imposed by the machine

·wind and weather conditions

·the presence of unauthorized personnel

·other possible unsafe conditions

Fundamentals

The workplace inspection helps the operator determine if the workplace is suitable for safe machine operation. It should be performed by the operator prior to moving the machine to the workplace.

It is the operator’s responsibility to read and remember the workplace hazards, then watch for and avoid them while moving, setting up and operating the machine.

18

Genie AWP Super Series

Part No. 114002

Image 20
Contents Operator’s Manual Contents Contact usSafety Rules Do Not Operate UnlessElectrocution Hazards Tip-over HazardsMaximum allowable side force Fall Hazards Collision HazardsImproper Use Hazard Bodily Injury HazardExplosion and Fire Hazard Damaged Machine HazardsLifting Hazard Battery and Charger Safety DC Models Burn HazardsExplosion Hazards Decal Legend AC and DC Models Air Models Platform Controls ControlsGround Controls Page Fundamentals Pre-operation InspectionBreather Cap AC & DC Models Pre-operation Inspection PRE-OPERATION InspectionObserve and Obey MaintenanceCheck the Battery DC Models Check the Hydraulic Oil Level Check the Tire Pressure RT Base ModelsCheck the Air Filter/Regulator Canister Air Models Scheduled MaintenanceCheck the Oil Lubricator Canister Drip Rate Air Models Function Tests Function Tests Setup Test Emergency StopTest Outrigger Interlock Workplace Inspection Workplace InspectionOperating Instructions Emergency Stop Platform Raise and LowerManual Lowering Auxiliary Platform Lowering AC & DC ModelsBattery Charging Instructions Battery and Charger Instructions Observe and ObeyTo Charge Battery Dry Battery Filling Charging InstructionsLifting Instructions Transport InstructionsTransport Instructions Observe and Obey Loading for Transport Transport InstructionsLoading the Machine With a Crane Securing the MachineWinching the Machine onto a Flatbed Truck Tilt-back Frame Tilt-back Operation InstructionsTilt-back Operation Instructions Observe and obey Lowering the Tilt-back Assembly Tilting Back the MachineStowing the Tilt-back Assembly Returning the Machine to Standing PositionDecals Inspection for Decals with WordsModels with Tilt-back Frame Models without Tilt-back Frame Inspection for Decals with Symbols Models with Tilt-back Frame Models without Tilt-back Frame Specifications Machine SpecificationsSpecifications Genie Scandinavia