Pre-operation Inspection, PRE-OPERATION Inspection

Third Edition • First Printing	Operator’s Manual

Pre-operation Inspection

oBe sure that the operator’s, safety and responsibilities manuals are complete, legible and in the storage container located on the platform.

oBe sure that all decals are legible and in place. See Decals section.

oCheck for battery fluid leaks and proper fluid level. Add distilled water if needed. See Maintenance section.

oAC & DC models: Check for hydraulic oil leaks and proper oil level. Add oil if needed. See Maintenance section.

oRT base models: Check for proper tire pressure. Add air to tires if needed. See Maintenance section.

oAir models: Check the oil level of the airline lubricator. See Maintenance section.

oAir models: Check the oil lubricator canister drip rate. Adjust as needed. See Maintenance section.

oAir models: Check the air filter/regulator canister. Drain water as needed. See Maintenance section.

Check the following components or areas for damage, improperly installed or missing parts and unauthorized modifications:

oElectrical components, wiring and electrical cables

oAC & DC models: Hydraulic power unit, hoses, fittings and cylinder

oAir models: Air power unit, air lines, fittings and cylinder

oPlatform entry mid-rail or gate

oSequencing cables and pulleys

oLifting chains and idler wheels

oNuts, bolts and other fasteners

oMast columns and counterweight

oBreather cap

oOutriggers, leveling jacks and footpads

oAdjustable glide pads

Check entire machine for:

oDents or damage

oCorrosion or oxidation

oCracks in welds or structural components

oInspect and clean battery terminals and all battery cable connections.

oBe sure that all structural and other critical components are present and all associated fasteners and pins are in place and properly tightened.

Part No. 114002

Genie AWP Super Series