Generac 004626-1, 004373-2, 004373-2, 004626-1 To Starter Solenoid RED Black To Engine Block

Page 51

Section 7 — Exploded Views and Parts Lists

(Model Nos. 004373-2 & 004626-1) Guardian Liquid-cooled 40 kW Generators

Battery – Drawing No. A6708-F

	TO STARTER
11	SOLENOID	6
11		6

	12	13	5	9
			5	9
				RED
				RED
				3
14				BLACK
				BLACK
TO ENGINE BLOCK				2
TO ENGINE BLOCK
	9			8
				8
	4

8

7

			7
ITEM	PART NO.	QTY. DESCRIPTION
2	058665	1	BATTERY 12VDC 90-AH 27F (NOT PROVIDED)
3	061902	1	HOLD DOWN BATTERY
4	059473	1	HOLD DOWN BATTERY
5	038805H	1	CABLE BATTERY BLACK #1 X 23.00
6	038804N	1	CABLE BATTERY RED #1 X 15.00
	038804T	1	CABLE BATTERY RED #1 X 31.00 (GEAR BOX-NON-GUARDIAN UNITS)
7	0A4010	2	SCREW HHC M8-1.25 X 60 FT G8.8
8	052858	2	NUT LOCK FLANGE M8-1.25
9	049820	2	NUT LOCK HEX M8-1.25 (NYLON INSERT)
11	023152	1	SCREW HHC 3/8-16 X 3/4 G5
12	022131	1	WASHER FLAT M10-3/8 ZINC
13	025507	1	WASHER SHAKEPROOF EXT 7/16 STL
14	022237	1	WASHER LOCK 3/8

Generac® Power Systems, Inc. 49

Image 51

Contents Power SYSTEMS, INC Authorized Dealer Location IntroductionSection Installation Drawings 56-57 Warranty Back Cover Safety Rules General InformationInstallation MaintenanceGeneral Hazards Electrical Hazards Generator AC Connection Systems Prepackaged Transfer SwitchUNPACKING/INSPECTION GeneratorSpecifications Main Circuit BreakerEngine Protective Devices Conversion to LP GAS Vapor Fuel Requirements RecommendationsGenerator and Load Compatibility EngineCoolant Emissions Control SystemAIR Fuel Ratio Controller Other Published Standards Standby Generator InstallationBasic Standby Electric System Nfpa StandardsEmergency Circuit Isolation Method Transfer Switch Start Signal ConnectionsPre-Packaged Type Switch GTS Type Engineered SwitchBattery Installation Preparation Before START-UPVented Batteries Prior to Initial START-UP Using the AUTO/OFF/MANUAL Switch Sequence of Automatic Operation OFF PositionManual Position Automatic Transfer OperationChecking the Engine OIL Level Weekly Exercise CycleEngine Oil Recommendations Oil and Filter Change ProcedureChanging the Engine AIR Cleaner Changing the Engine OIL and FilterSpark Plugs Battery MaintenanceDC Fuse Miscellaneous MaintenanceCleaning the Generator Overload Protection for Engine DC Electrical SystemOUT of Service Procedure Removal From ServiceReturn To Service SYSTEM/COMPONENT Procedure Frequency Service ScheduleProblem Cause Correction Troubleshooting GuideElectrical Data Section Generac Generac Power Systems,Inc Electrical Data Electrical Data Electrical Data Wiring Diagram Customer Connection HRS Power Systems IncPart NO. QTY. Description Generators Part NO. QTY Description Part NO.QTY Description QTY Description 4640 31 33 Washer Flat 3/8-M10 Zinc Part NO.QTY. DescriptionExploded Views and Parts Lists Flywhl 4.3L GM SAE Stator Leads Scrolldetail To Engine Flywheel QTY Description Part NO. QTY Description QTY Assembly Cover AccessRadiator Copper Brass Gasket Carburetor Adaptor Gasket Carb Impco To Carburetor QTY. DescriptionSupport Solenoid NAT GAS QTY. Description To Starter Solenoid RED Black To Engine Block ALT Leads Sensing Wire Siemens FD 3 Pole QTY Description Exploded Views and Parts Lists Part NO. QTY. Description Muffler 2-1/2 INLET/OUTLET Guardian Liquid-cooled 40 kW Generators Installation Drawings 12V Battery see Note Lifting EYE Places This Warranty Shall not Apply to the Following Warranty Schedule