Craftsman MGP-670070, 919.670070 owner manual Service Adjustments, Storage, Carburetor, Governor

Page 20

GFCI receptacle (Ground Fault Circuit Interrupter)

For maximum protection against electrical shock the GFCI should be tested monthly.

To test:

1.Depress the TEST button. The RESET button should extend. If the RESET button does not extend, notify a Authorized Service Center.

2.To restore power, depress the RESET button firmly into the GFCI unit until an audible click is heard. If reset properly, the RESET button is flush with the surface of the test button. When the button stays in, the power is ON.

TEST MONTHLY

RESET

RESET

TEST TEST

SEE INSTRUCTIONS

SERVICE ADJUSTMENTS

CARBURETOR

The carburetor of your generator is pre-set at the fac- tory. The carburetor should not be tampered with. If your generator is used at an altitude in excess of 4000 feet performance may be affected. If so consult with your nearest Craftsman Service Center regarding high altitude set changes.

GOVERNOR

Your engine governor maintains the constant operating speed of your generator. DO NOT tamper with the en- gine governor which is factory set for proper engine speed.

Over-speeding your engine above factory high speed set- ting can be dangerous and could possibly cause per- sonal injury or property damage. If you believe the en- gine is running too fast or slow, take your generator to a Authorized Craftsman Service Center for repair and ad- justment.

Low engine speeds impose a heavy load on the engine and when sufficient power is not available the engine

life could be shortened.

STORAGE

If you are going to store your generator for more than 30 days, use the following information as a guide to prepare the generator for storage.

Never store generator with fuel in the tank indoors or

in enclosed, poorly ventilated areas, where fumes can reach an open flame, spark or pilot light as on a furnace, water heater, clothes dryer or other gas appliances.

Engine Preparation

•Add fuel stabilizer to fuel tank to minimize the formation of fuel gum deposits during storage.

•Run engine at least 10 minutes after adding stabilizer to allow it to enter the fuel system.

•Disconnect the spark plug wire and remove the spark plug.

•Add one teaspoon of oil through the spark plug hole.

•Place rag over spark plug hole and pull the recoil a few times to lubricate the combustion chamber.

Replace the spark plug, but do not connect the spark plug wire.

NOTE: If a fuel stabilizer is not used, all gasoline must be drained from the tank and carburetor to prevent gum deposits from forming on these parts and causing pos- sible malfunction of the engine.

Generator

•Clean the generator as outlined in the Generator Maintenance paragraph on page 18.

•Check that cooling air slots and openings on generator are open and unobstructed.

Battery

•Store battery as described by the battery manu- facturer.

NOTE: After storing battery for a long period of time it may lose it's charge. If the battery loses it's charge, manually start the engine with the battery connected. The engine will recharge the battery as it runs.

MGP-670070

20 — ENG

Page 19 Page 21
Image 20
Page 19 Page 21
Contents Sold by Sears Canada, Inc., Toronto, Ont. M5B2B8 Owners ManualGenerator Table of Contents Safety Guidelines Definitions Important Safety InstructionsHazard What could Happen HOW to Prevent IT Risk of Electrocution and FireRisk of Electrocution and Fire cont’d Risk of Fire Or wall. do not Operate UnitIndoors or in ANY CON Fined AreaRisk of Breathing Inhalation Hazard Read and Understand ALL Warnings BeforeProtector will void the warranty Risk of Unsafe OperationL. listed voltage surge On your generatorRisk from Lifting Risk of HOT SurfacesRisk of Moving Parts Assembly Carton ContentsTools Needed for Assembly Remove Generator from CartonInstallation of Battery Negative Battery Cable Connection Star WasherGrounding the Generator Nut SolenoidInstalling Wheel KIT Not shown OperationKnow Your Generator Receptacles LOW OIL ShutdownGenerator Capacity Obtaining Electricity from GeneratorConnecting Generator To Main Electrical Supply Before Starting EngineAdding Engine Oil GasolineFor recoil start To Start Your GeneratorStopping Engine Maintenance Connecting Electrical LoadsMaintenance Task Customer Responsibilities TableGeneral Recommendations Generator MaintenanceEngine Maintenance Clean and Replace Spark Plug Air CleanerClean Cooling System Replace Fuel In-Line FilterService Adjustments StorageCarburetor GovernorTroubleshooting Guide Problem Cause CorrectionOwner’s Warranty Responsibilities Emissions Control Systems StatementENG ENG ENG Service and Repair Parts Génératrice DE Vendu par Sears Canada, Inc., Toronto, Ont. M5B 2B8Entente D’ENTRETIEN Responsabilités DU ClientRisques Prévention Risques Délectrocution ET D’INCENDIEConserver CES Directives Risques D’INCENDIE Rieur OU Dans UN Endroit ClosRisques AUX Voies Respiratoires ET Risques D’INHALATION Les moteurs à essence produisent Risques D’UNE Utilisation Dangereuse GénératriceRisques Lors DU Levage Risques Reliés AUX Surfaces ChaudesRisques Reliés AUX Pièces Mobiles Contenu DE L’EMBALLAGE Sac à piècesPièces et boîte à pièces pour l’ensemble de roues Sac à pièces pour la pose de la batterieOutils Requis Pour L’ASSEMBLAGE Retrait DE LA Génératrice DE SON EmballageÉcrou Solénoï de Pose Typique D’UNE BatterieMise À LA Terre DE LA Génératrice Pose DE L’ENSEMBLE DE Roues Support du MoteurFonctionnement Bien Connaître Votre GénératricePrises Dispositif D’ARRÊT Suite À UN Niveau BAS D’HUILECapacité DE LA Génératrice Comment Obtenir DE L’ÉLECTRICITÉ DE LA GénératriceAvant DE Démarrer LE Moteur Essence Remplissage d’huile moteurDémarrage du moteur Arrêt du moteurDémarrage électrique Démarrage à rappelEntretien Tableau DES Responsabilités DU ClientBranchement DE Charges Électriques Tâche D’ENTRETIENRecommandations Générales Entretien DE LA GénératriceEntretien DU Moteur HuileNettoyage et remplacement de la bougie dallumage Remplacement du filtre à carburant en ligneFiltre à air Nettoyage du système de refroidissementDirectives Pour L’ENTREPOSAGE Réglages D’ENTRETIENEntreposage Guide DE Dépannage Problème Cause CorrectionResponsabilités de garantie du propriétaire Remarque Remarque Remarque Entretien ET Pieces DE Rechange

MGP-670070, 919.670070 specifications

The Craftsman 919.670070, also known as MGP-670070, is a premier solution for those seeking a reliable and efficient air compressor. This model stands out in the crowded market of air compressors due to its robust design and versatile functionality, making it a go-to choice for both professionals and DIY enthusiasts.

One of the primary features of the Craftsman 919.670070 is its powerful motor. With a horsepower rating that ensures high performance, it delivers a consistent airflow suitable for a variety of tasks, from inflating tires to powering pneumatic tools. This capability makes it an ideal asset for both home workshops and professional garage settings.

The tank capacity of the MGP-670070 is another highlight. With a sizeable tank, it can store ample compressed air, allowing users to complete larger tasks without the need for frequent refills. This characteristic greatly enhances productivity, as users can work without interruption.

Portability is a significant consideration for many users, and the Craftsman 919.670070 excels in this aspect. Its compact design, combined with sturdy wheels and a comfortable handle, ensures that it can be easily transported from one location to another, making it perfect for job sites or moving around the home.

Safety features have not been overlooked in the design of the MGP-670070. It comes equipped with an automatic shut-off mechanism that activates when the desired pressure is reached, preventing over-pressurization and extending the lifespan of the machine. Additionally, it often includes a thermal overload protection system that helps protect the motor from overheating.

The compressor's user-friendly control panel features gauges that provide clear readings of both tank pressure and outlet pressure, ensuring that users can monitor performance easily. Coupled with quick-connect fittings, the MGP-670070 allows for fast and uncomplicated hose connections, streamlining the workflow.

Technologically, this model includes a noise-reduction design that operates at lower decibel levels compared to traditional compressors. This feature makes it particularly appealing for use in residential areas where noise can be a concern.

In summary, the Craftsman 919.670070, MGP-670070, is not just another air compressor on the market; it embodies a combination of power, efficiency, and user-centric design. Whether you are a seasoned professional or a weekend warrior, this compressor meets various needs with reliability and ease of use, making it a valuable addition to any toolkit.
Top Page Image Contents