Briggs & Stratton 30237 Maintenance Section, Specifications, General Maintenance Recommendations

Page 15

Maintenance Section

5

SPECIFICATIONS

Starting Wattage . . . . . . . . . . . . . . . . . . . . . .13,500 watts Wattage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7,800 watts AC Load Current:

At 120 Volts . . . . . . . . . . . . . . . . . . . . . . . . .65.0 Amps At 240 Volts . . . . . . . . . . . . . . . . . . . . . . . . .32.5 Amps Phase . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1–phase Rated Frequency . . . . . . . . . . . . . . . . . . . . . . . . .60 Hertz Fuel Tank Capacity . . . . . . . . . . . . . 7 U.S. gallons (26.5 l) Shipping Weight . . . . . . . . . . . . . . . . . . 250 lbs. (113.4 kg)

GENERAL MAINTENANCE RECOMMENDATIONS

The Owner/Operator is responsible for making sure that all periodic maintenance tasks are completed on a timely basis; that all discrepancies are corrected; and that the unit is kept clean and properly stored. NEVER operate a

damaged or defective generator.

NOTE: If equipped with inflatable tires, keep the air pressure at the value marked on the tire or within 15 and 40 psi.

Engine Maintenance

See engine owner’s manual for instructions.

An oil drain tray is provided for your convenience to change the oil and oil filter. Store tray in a convenient location for periodic maintenance.

2.Place the oil drain tray foot tab in the slot on the base of the generator, as shown.

3.Follow the instructions given in the engine owner’s manual for draining oil.

4.After oil has drained, reinstall the oil drain plug.

5.Remove the oil drain tray from under the oil drain plug and clean up any spilled oil.

Changing Oil Filter

1.Place the half moon notch in the oil drain tray under the oil filter (Figure 17).

Figure 17 — Changing Oil Filter With Oil Drain Tray

drain tray

notch

drain tray foot

2.Place the oil drain tray foot tab in the slot on the base of the generator, as shown.

3.Follow the instructions given in the engine owner’s manual for changing oil filter and adding oil.

4.Remove the oil drain tray from under the oil filter and clean up any spilled oil.

Changing Oil

1.Place the half moon notch in the oil drain tray under the oil drain plug (Figure 16).

Figure 16 — Changing Oil With Oil Drain Tray

drain tray notch

drain tray foot

CAUTION

Avoid prolonged or repeated skin contact with used motor oil.

Used motor oil has been shown to cause skin cancer in certain laboratory animals.

Thoroughly wash exposed areas with soap and water.

KEEP OUT OF REACH OF CHILDREN. DON'T POLLUTE. CONSERVE RESOURCES. RETURN USED OIL TO COLLECTION CENTERS.

15

Image 15
Contents Manual No GS Revision 2 08/15/2005 Questions? Preguntas? Helpline 1-888-611-6708 M-F8-5 CTTable of Contents Safety RulesEquipment Description When Transporting or Repairing Equipment When Adding or Draining FuelWhen Starting Equipment When Operating EquipmentWhen Adjusting or Making Repairs to Your Generator When Testing for Engine SparkReflective exhaust heat may damage fuel tank causing fire Know Your Generator Features and Controls SectionAssembly Remove Generator From CartonAttach Handle Add Engine Oil AssemblyRemove Cover on Start Switch Before Starting the EngineSystem Ground Using the GeneratorConnecting to a Building’s Electrical System Section OperationStarting the Engine Jump Start ProcedureOperation Operating the GeneratorDo not Overload GENERATOR. See Don’t Overload Generator Connecting Electrical LoadsCharging a Battery Stopping the EngineCold Weather Operation How to Use the Battery ChargerCord SET Generator Adapter120/240 Volt AC, 30 Amp, Locking Receptacle ReceptaclesVolt DC, 10 Amp Receptacle Volt AC, 20 Amp, Duplex ReceptaclesExample Power ManagementDont Overload Generator CapacityEngine Maintenance Maintenance SectionSpecifications General Maintenance RecommendationsGenerator Cleaning MaintenanceGenerator Maintenance Battery MaintenanceEngine Storage Other Storage Tips StorageStorage Generator StorageSection Troubleshooting TroubleshootingProblem Cause Correction Portable Generator Years 2nd year parts only TROY-BILT Owner Warranty Policy Effective November 1About your equipment warranty Equipment Consumer Use Commercial UseReglas DE Seguridad Reglas de SeguridadConserve Estas Instrucciones Tabla DE Contenidos Descripción DEL EquipoPeligro Sección 1 Reglas de SeguridadCuando Pruebe LA Bujía DEL Motor Sección 1 Instrucciones de SeguridadPrecaución Cuando Ajuste O Haga Reparaciones a SU GeneradorAceite Llena la Tapa Agrega aceite al motor aquí Características y MandosConozca SU Generador Placa de CaracterísticasFije el Asa MontajeMontaje Para Retirar El Generador De La CajaAgregue Combustible Sección 3 MontajeAntes DE Darle Arranque AL Motor Agregar Aceite al MotorUbicación del Generador OperaciónUSO DEL Generador Tierra del SistemaProcedimiento de Arranque en Puente Sección 4 OperaciónOperando EL Generador Encienda el MotorNo Sobrecargue EL GENERADOR.Vea No Sobrecargue Generador Conexion De Cargas ElectricasParado Del Motor Carga de la BateriaCargador de Batería Operación Durante UN Clima FríoFigura 28 Refugio Frío Permanente del Tiempo Volt AC, 20 Amp, Receptáculos Dobles Juego DE Cables DEL Adaptador DEL GeneradorReceptáculos Precaución Tomacorrientes de 12 Voltios DCEjemplo No Sobrecargue EL GeneradorCapacidad Control de la EnergíaMantenimiento del Motor MantenimientoEspecificaciones Recomendaciones Generales DE MantenimientoPlaca de Características Sección 5 MantenimientoMantenimiento del Generador Para Limpiar el Generador Mantenimiento de la BateríaAlmacenamiento & Diagnosticos de Averías Diagnositicos DE AveríasAlmacenamiento Acerca de la seguridad de su equipo Efectiva desde el 1 ro de NoviembreEquipo Para Uso Del Consumidor Para Uso Comercial Garantía Limitada