Briggs & Stratton 206494GS Generator produces hazardous voltage, When Testing for Engine Spark

Page 6

WARNING

Generator produces hazardous voltage.

Failure to isolate generator from power utility can result in death or injury to electric utility workers due to backfeed of electrical energy.

When using generator for backup power, notify utility company. Use approved transfer equipment to isolate generator from electric utility.

Use a ground fault circuit interrupter (GFCI) in any damp or highly conductive area, such as metal decking or steel work.

DO NOT touch bare wires or receptacles.

DO NOT use generator with electrical cords which are worn, frayed, bare or otherwise damaged.

DO NOT operate generator in the rain or wet weather.

DO NOT handle generator or electrical cords while standing in water, while barefoot, or while hands or feet are wet.

DO NOT allow unqualified persons or children to operate or service generator.

WARNING

Contact with muffler area can result in serious burns.

Exhaust heat/gases can ignite combustibles, structures or damage fuel tank causing a fire.

DO NOT touch hot parts and AVOID hot exhaust gases.

Allow equipment to cool before touching.

Keep at least 5 feet (1.5 m) of clearance on all sides of generator including overhead.

Code of Federal Regulation (CFR) Title 36 Parks, Forests, and Public Property require equipment powered by an internal combustion engine to have a spark arrester, maintained in effective working order, complying to USDA Forest service standard 5100-1C or later revision. In the State of California a spark arrester is required under section 4442 of the California Public resources code. Other states may have similar laws.

WARNING

Starter and other rotating parts can entangle hands, hair, clothing, or accessories.

NEVER operate generator without protective housing or covers.

DO NOT wear loose clothing, jewelry or anything that may be caught in the starter or other rotating parts.

Tie up long hair and remove jewelry.

WARNING

Unintentional sparking can result in fire or electric shock.

WHEN ADJUSTING OR MAKING REPAIRS TO YOUR GENERATOR

Disconnect the spark plug wire from the spark plug and place the wire where it cannot contact spark plug.

WHEN TESTING FOR ENGINE SPARK

Use approved spark plug tester.

DO NOT check for spark with spark plug removed.

CAUTION

Excessively high operating speeds increase risk of injury and damage to generator.

Excessively low speeds impose a heavy load.

DO NOT tamper with governed speed. Generator supplies correct rated frequency and voltage when running at governed speed.

DO NOT modify generator in any way.

NOTICE

Exceeding generators wattage/amperage capacity can damage generator and/or electrical devices connected to it.

DO NOT exceed the generator’s wattage/amperage capacity. See Don’t Overload Generator in the Operation section.

Start generator and let engine stabilize before connecting electrical loads.

Connect electrical loads in OFF position, then turn ON for operation.

Turn electrical loads OFF and disconnect from generator before stopping generator.

NOTICE

Improper treatment of generator can damage it and shorten its life.

Use generator only for intended uses.

If you have questions about intended use, ask dealer or contact local service center.

Operate generator only on level surfaces.

DO NOT expose generator to excessive moisture, dust, dirt, or corrosive vapors.

DO NOT insert any objects through cooling slots.

If connected devices overheat, turn them off and disconnect them from generator.

Shut off generator if:

-electrical output is lost;

-equipment sparks, smokes, or emits flames; -unit vibrates excessively.

6

BRIGGSandSTRATTON.COM

Image 6
Contents Operator’s Manual Engine Where to Find UsGenerator Date PurchasedTable of Contents Safety alert symbol is used with a signal word Operator SafetySafety Rules Hazard Symbols and MeaningsEngine exhaust from this product contains Broken bones, fractures, bruises, or sprains could resultGenerator produces hazardous voltage When Adjusting or Making Repairs to Your GeneratorWhen Testing for Engine Spark Contact with muffler area can result in serious burnsInstall Wheel Kit AssemblyShipment Contents Unpack GeneratorFuel must meet these requirements Clean area around fuel fill cap, remove capAdd Fuel High AltitudeGenerator Location Connecting to a Building’s Electrical SystemSystem Ground Special RequirementsFeatures and Controls 120/240 Volt AC, 30 Amp, Locking Receptacle Cord Sets and ReceptaclesNema L14-30 Volt AC, 20 Amp, Duplex ReceptaclesOperation Starting the EngineConnecting Electrical Loads Stopping the EngineMove fuel valve to Off position Don’t Overload Generator Wattage Reference GuideMaintenance Maintenance ScheduleGenerator Maintenance Checking Oil Level Engine MaintenanceOil Recommendations Adding Engine OilService Spark Arrester Service Air CleanerService Spark Plug Clean and inspect the spark arrester as followsClean Cooling System Carburetor AdjustmentCheck Valve Clearance Storage Troubleshooting Emissions Control System Warranty Owner’s Warranty ResponsibilitiesWarranties Maintenance Emission InformationClaims and Coverage Exclusions Limited Warranty AC Load Current Product SpecificationsCommon Service Parts 800Manual del Operario Motor Dónde encontrarnosGenerador Fecha de compraMontaje Resolución de problemas GarantíasSeguridad de operario Controles y característicasReglas de seguridad Seguridad de operarioDescripción del equipo Símbolos de peligro y sus significadosPeligro Precaución Contenido de la caja MontajeDesembalaje del generador Instale el juego de ruedasAgregue combustible El combustible debe reunir los siguientes requisitosGran altitud Ubicación del generador Tierra del sistemaConexión al sistema eléctrico de un edificio Requisitos especialesControles y características Del motor y está equipado con una pantalla apagachispasJuegos de cordones y enchufes conectores Dispositivo de seguridad de 120/240 V, 30 aToma eléctricas dobles de 120 V CA y 20 a Operando Encienda el motorEl motor podría petardear, incendiarse o dañarse Conexión de cargas eléctricasParada del motor Gire la válvula de combustible blanca hasta la posición OffEjemplo No sobrecargar el generadorCapacidad Control de la energíaRecomendaciones generales MantenimientoPlan de mantenimiento Control de emisionesComprobación del nivel de aceite Mantenimiento del motorAceite Recomendaciones sobre el aceite Adición de aceite del motorServicio del depurador de aire Servicio del bujíaLimpie la pantalla apagachispas Comprobación de holgura de la válvula Limpie e inspeccione el apagachispas de la siguiente maneraSistema de refrigeración de aire Ajuste del carburadorAlmacenamiento Resolución de problemas Problemo Causa AccionResponsabilidades de la garantía del propietario GarantíasGarantía del sistema de control de emisiones Operaciones de mantenimiento que se enumeran en lasInformación sobre emisiones Garantía Limitada Especificaciones del producto Servicio común despideCorriente Carga de C.A