Craftsman C950-52930-0 owner manual Speed Select Lever

NEED PARTS? VISIT HTTP://WWW.MANUALBUDDY.COM/PARTS

ASSEMBLY

SPEED SELECT LEVER

1.Cut plastic tie securing speed select lever assembly to the shifter bracket. (See Figure 9)

2.Remove Iocknut, washer, spring, and the bolt. (See Figure 11)

3.Position speed selector lever assembly as shown in Figure 10.

4.Reinstall bolt, spring, washer and Iocknut. (See Figure 11)

5.Tighten locknut until 1/8 to 3/16 inch of the bolt threads protrude past the locknut

6.Thread the 3/8-16" hex jam nut onto the lever until the nut reaches the end of the thread. (See Figure 11)

7.Thread the plastic knob as far as possible and ensure that the knob points forward.

8.Tighten the 3/8-16" hex jam nut against the knob secure- ly.

9.Move shifter through all speeds to ensure proper tension of the spring. If shifter lever sticks in any of the notches, loosen Iocknut 1/2 turn at a time until shifter lever moves more freely.

10.If adjustment of speed of snow blower is needed, refer to "Friction Wheel Adjustment" in the ADJUSTMENT/RE- PAIR section.

Shifter Bracket \ 0 %

Plastic Tie_ (

Shift Lever

Figure 9

Shifter Bracket

Control Panel

Figure 10

NOTE: View is from rightside of unit standing in operator's position.

Plastic(pointedKnob _c:::_	_8-16	Hex Jam Nut
forward)		Shifter Bracket

Locknut

Control Panel

1/8 to 3/16 inch of

Exposed Thread

' Spring

Figure 11

F-0OIOO8J 10

NEED PARTS? VISIT HTTP://WWW.MANUALBUDDY.COM/PARTS/