Craftsman C950-52930-0 owner manual Service Recommendations, Procedure, After Each USE

NEED PARTS? VISIT HTTP://WWW.MANUALBUDDY.COM/PARTS

SERVICE RECOMMENDATIONS

SERVICE RECOMMENDATIONS

		FIRST	BEFORE	EVERY	EVERY	EVERY	BEGINNING
	PROCEDURE	2	EACH	5	10	25	EACH	BEFORE
		HOUR	USE	OFTEN HOURS	HOURS	HOURS	SEASON	STORAGE
S	Tightenall screws and nuts	_/		_/
N	Check Traction Clutch
	Cable Adjustment	_/

O(See Cable Adjustment)

W

B	Check Auger clutch Cable	_/
	Adjustment
L	(See Cable Adjustment)
O	Adjust Drive Belts	_/		_
W
E	Lubricate Chains and				_
R	Hex Shaft
	Lubricate Auger Shaft (See			_
	Shear Bolt Replacement)
E
N	Oil, Check	_/	4		4
G
I
N	Oil, Change	_/		4	4
E

The warranty on this snow blower does not cover items that have been subjected to operator abuse or negligence. To re- ceive full value from the warranty, operator must maintain snow blower as instructed in this manual. The following Ser- vice Recommendations is supplied to assist operator to properly maintain snow blower. This is a check list only. Ad-

justment referred to will be found in Adjustments/Repairs section of this manual.

AFTER EACH USE

1.Check for any loose or damaged parts.

2.Tighten any loose fasteners.

3.Check and maintain the auger.

4.After each use, remove all snow and slush offthe snow blower to prevent freezing of auger or controls.

5.Check controls to make sure they are functioning proper- ly.

6.If any parts are worn or damaged, replace immediately.

F-001008J 20

NEED PARTS? VISIT HTTP://WWW.MANUALBUDDY.COM/PARTS/