
NEED PARTS? VISIT HTTP://WWW.MANUALBUDDY.COM/PARTS
ADJUSTMENT/REPAIR
BELT GUIDE ADJUSTMENT
1.Remove spark plug wire.
2.Have someone engage auger drive.
3.Measure the distance between the belt guide and belt. The distance should be 1/8 inch (3.175 mm) for guide. See Figure 33.
4.If adjustment is necessary, loosen belt guide mounting bolt. Move belt guide to the correct position. Tighten mounting bolt.
l |
| j | Belt Guide |
| |
O | 1/8Inch(3175 |
| |||
|
|
|
|
| |
Auger idler __ |
| /...,,._'_ | . | mm) |
Pulley Engaged L__
5.Reinstall belt cover.
Figure 33
6.Reconnect spark plug wire.
CABLE ADJUSTMENT - TRACTION DRIVE AND AUGER DRIVE
The cables are adjusted at the factory and no adjustment should be necessary, if the cables have become stretched or are sagging adjustment wilt be necessary.
Whenever belts are adjusted or replaced, the cables will need to be adjusted.
To check for correct adjustment unhook "Z" fitting at clutch lever (see Figure 34):
1.Move clutch lever to the full forward position (just con- tacting plastic bumper). Holding cable tight, note posi- tion of fitting to hole in clutch lever.
2.The center of the "Z" fitting should be between the centre and top of the hole in the clutch lever.
If Adjustment is Necessary (see Figure 35)
,_ fromWARNING:fireor Drainflame. the gasoline outdoors, away
1.Remove gas from gas tank.
2.Stand blower on end.
3.Push cable through spring to expose the threaded por- tion of the cable.
4.Hold square end of threaded portion with pliers and ad- just Iocknut in or out until correct adjustment is reached.
Pull cable back through spring and connect cable. |
|
27 |
"Z" Fitting | Control | lever | |
| forward | position | |
| (just | contacting | |
| plastic bumper) | ||
| when | checking | |
| cable | length. | |
| must | be in full |
Plastic
Bumper
Figure 34
Squa_
Cable
Spdng
Locknut
Figure 35
NEED PARTS? VISIT HTTP://WWW.MANUALBUDDY.COM/PARTS/