_hb safetyARNING:glassesAlwaysor eyewearshields while assembling snow
thrower.
TOOLS REQUIRED FOR
ASSEMBLY
1 - Knife to cut carton
2 - 1/2 inch wrenches
(or adjustable wrenches)
2 - 9/1 6 inch wrenches
(or adjustable wrenches)
2 - 3/4 inch wrenches
(or adjustable wrenches)
1 - Pliers (to spread cotter pin)
1 - Screwdriver
1 - Measuring tape or ruler
TO REMOVE SNOW THROWER
FROM CARTON
1.Locate all parts packed separately and remove from the carton.
NOTE: Place fuel stabilizer in a safe place until needed for storage.
2.Remove and discard the packing material from around the snow
thrower.
3.Cut down all four corners of the car- ton and lay the panels flat.
4.Cut the straps that secure the axle to the pallet.
5.For shipping purposes, the height adjust skids are attached to the pallet. Remove the screw that se- cures each height adjust skid to the pallet. See Figure 2.
6.Roll snow thrower off the pallet by pulling on the lower handle. CAU- TION: DO NOT back over control cables.
7.Remove all packing material from the unit.
8.Cut ties securing the clutch control
cable to the lower handle and lay F 0410108L
o
Figure 1
Figure 1 shows the snow thrower in the shipping position.
Figure 2 shows the snow thrower com- pletely assembled.
References to the right or left hand side of the snow thrower are from the view-
point of the operator's position behind the unit.
cable back away from the motor frame.
Height
Adjust
Skid
Figure 2