Craftsman 536.886141 Customer Responsibilities, You complete, Service Schedule Records Dates

snow blowing is accomplished when the snow is removed immediately after it falls.

o For complete snow removal, slightly over- lap each path previously taken. Use more overlap in deep snow to prevent overloading.

o The snow should be discharged down wind whenever possible, in windy condi- tions, lower the chute deflector to direct discharged snow close to the ground, where it is less likely to blow into un- wanted areas.

•For normal usage, set the skids so that the scraper bar is t/8" above the skids_ For extremely hard-packed snow sur- faces, adjust the skids upward so that the scraper bar touches the ground°

•On gravel or crushed rock surfaces, set the skids at 1-1/4" below the scraper bar (See To Adjust Skids Height paragraph on page 17). Stones and gravel must not be picked up and thrown by the machine.

After the snow throwing job has been

completed, allow the engine to idle for a few minutes, which will melt snow and

accumulated ice off the engine.

Clean the snow thrower thoroughly after each use.

Remove ice and snow accumulation and all debris from the entire snow thrower, and flush with water (if possible) to re- move all salt or other chemicals. Wipe snow thrower dry.

:JRODUCT SPECIFICATIONS

HORSE POWER: 5HP

DISPLACEMENT" 12.04 cu. in.

GASOLINE CAPACITY: 2 quart (unleaded)

L L ,,, ,,
OIL (20	oz. Capacity)"	5W-30
SPARK	PLUG:	Champion	RJ19LM
		(Gap °030) or
		Equivalent
VALVE	CLEARANCE: Intake: .0I0 In.
		Exhaust:	.010 in.

CUSTOMER			RESPONSIBILITIES
SERVICE						SCHEDULE
RECORDS										SERVICE
										DATES
Fill in dates			as	After	Before As J	Every '""Every'"Each			Before
you complete				first 2	Each Neede	10	25	Season Storage
				Hoursl	Use	Hours	Hours
regular servme
	, ,,		..	=	:			........
Check Engine		Oil Level			_			_	_.
	,,,,	,, ,,,,,,,,					p_
Change EngineOil
Tighten all screws andnuts				_	P'_
Check TractionClutch Cable
A; ju tmentCSe; ;				eAdjv"				Ii'	==	_-
				.........
Replace	Spark Plug						jvJ
Check	Ddve Belts							p_'
Lubricateall pivot points						jv_
Drain Fuel									iv_
Adjustment (See			Cable Adj)	tJ t
LubricateDisc Drive Plate Zerk							_r		_r

!4