Husqvarna 927SB, 96193004400 owner manual Exploded

Page 22

REPAIR PARTS

AUGER HOUSING / IMPELLER ASSEMBLY

SNOW THROWER - MODEL NO. 927SB (96193004400), PRODUCT NO. 961 93 00-44

			11
			6
15			16
14		12	16
13		12
13			11
			11
4
12	3
	3		10
	11		10
	1

34	30
	30
	31
	31
	29

18 19

28 27

24 23

01.07.004-B

20 21

2 (EXPLODED)

NOTE: All component dimensions given in U.S. inches. 1 inch = 25.4 mm

IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. Failure to do so could be hazardous, damage your snow thrower and void your warranty.

Image 22

Contents 927SB Safe Operation Practices for Walk-Behind Snow Throwers Table of Contents Parts Packed Separately in Carton Assembly / PRE-OPERATIONHOW to SET UP Your Snow Thrower Remove Snow Thrower from CartonInstall Traction Drive Control ROD See Figs Install Speed Control ROD See FigsUnfold Upper Handle Install Auger Control ROD See Figs Install Discharge Chute / Chute Rotator Head See FigPrimer OperationKnow Your Snow Thrower Ignition KEYRecoil auxiliary starter handle used for starting Meets A.N.S.I. Safety RequirementsDrive speed control lever used to select forward or HOW to USE Your Snow Thrower StoppingTo Move Forward and Backward See Fig When traction drive control lever is engagedUsing the CLEAN-OUT Tool See Fig To Throw Snow See FigScraper BAR See Fig To Adjust Skid Plates See FigBefore Starting the Engine Check Engine OIL Level See FigBefore Stopping Snow Throwing TipsTo Start Engine If Recoil Starter has FrozenMaintenance Cleaning EngineChute Deflector Service and AdjustmentsTo Adjust Snow Thrower Height Shear Bolts See FigTo Replace Belts See Fig Engine Speed StorageCarburetor Fuel SystemOther CylinderTroubleshooting Scraper BAR Auger Housing / Impeller AssemblyKEY Part Description Auger BearingAuger 27 LH Auger 27 RHExploded Bearing 532 19 67-10 Gearbox AssemblyImpeller Tool ClipStrap Repair Parts532 18 41-13 Deflector Weldment Knob BlackControl Panel / Discharge Chute Bulb Handles532 42 14-48 Headlight Bezel Gray Lower Tube01.08.004-B Knob RED SpacerRetainer Handle KnobClutch ROD 532 18 04-80 Impeller ROD Assembly532 40 57-40 Traction ROD Assembly Rear PlateDrive HEX Shaft 532 17 53-44 Trunnion Bearing AssemblyControl Shaft Assembly Pinion Gear3534 532 19 84-74 Speed Selector Head Assembly 532 18 40-74 Idler Pivot BracketAssembly 532 17 93-54 Idler Traction ARM Idler PulleyGear Axle ShaftRoll PIN 3/16 Clik PINFrame ENGINE, TECBottom PAN Pulley Chassis / Engine / PulleysImpeller Belt Wheel Assembly LH WheelsBAG of Parts Power CordKEY Part Description 532 03 50-62 Safety Ignition KEY Retainer PINDecals 532 18 10-35 DECAL, DANGER, DeflectorWarranty Statement