PARTS PACKED SEPARATELY IN CARTON
(1) AUGER CONTROL ROD
(1) TRACTION DRIVE CONTROL ROD
(1) MULTI-
WRENCH
(180684)
(2) FLAT WASHERS
| (1) POWER CORD |
|
(1) DISCHARGE CHUTE | (198563) | (3) RETAINER |
| ||
|
| |
|
| SPRINGS |
|
| (169675) |
ROTATOR HEAD MOUNTING
(2) CARRIAGE BOLTS
(1) WASHER 3/8 | (1) LOCKNUT 3/8 | (1) SAFTEY IGNITION KEY | |
(35062) | |||
(19131316) | (73800600) | ||
|
(2) HANDLE KNOBS
EXT
RA SHEAR BOLTS AND NUTS
(6) SHEAR BOLTS | (6) SPACERS | (6) LOCKNUTS |
(198636) | (198638) | |
|
| (73800400) |
ASSEMBLY / PRE-OPERATION
Read these instructions and this manual in its entirety before you attempt to assemble or operate your new snow thrower. Reading the entire manual will familiar- ize you with the unit, which will assist you in assembly, operation and maintenance of the product.
Your new snow thrower has been assembled at the factory with the exception of those parts left unassembled for ship- ping purposes. All parts such as nuts, washers, bolts, etc., necessary to complete the assembly have been placed in the parts bag. To ensure safe and proper operation of your snow thrower, all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to ensure proper tightness.
REMOVE SNOW THROWER FROM CARTON
1. Remove all accessible loose parts and parts boxes |
|
from carton. | 4 |
|
2.Cut down all four corners of carton and lay panels flat.
3.Remove the two (2) screws securing the auger housing to the pallet.
4.Remove all packing materials except plastic tie holding speed control rod to lower handle.
5.Remove the two (2) plastic ties securing the upper handle to the pallet.
6.Remove snow thrower from carton and check carton thoroughly for additional loose parts.
HOW TO SET UP YOUR SNOW THROWER
TOOL BOX (See Fig. 8)
A toolbox is provided on your snow thrower. The toolbox is located on top of the belt cover. Store the extra shear bolts, nuts and