Screws,
M2.5x4mm (2)
Screws,
M2.5x4mm (2)
Figure 11. Removing the Hard Disk Tray
Reassembly Notes
•Insert the connector end of the drive through the opening in the tray, then lower the drive into place.
•Carefully slide the hard drive assembly into its compartment. Press firmly to make sure the connector seats properly.
Important
If you are installing a new hard disk drive, install the factory software and operating system on the drive before loading any additional
zt1100/xz200 and xt1500 Series | Removing and Replacing Parts | 43 |
Troubleshooting and |
|
|