Sanyo XG-705A owner manual Wireless Setting, Password

6. Configurations with Browser

Wireless Setting

Wireless related items can be configured on this screen.

This screen will not be displayed at Wired LAN setting.

Parameter	Description
Wireless Mode	Select the Communication standard 802.11b or 802.11b.g
Network Type	Select either “Infrastructure” or “AdHoc”.
SSID*	Set the SSID/ESSID. (up to ASCII 32 characters)
	SSID/ESSID is case-sensitive. Even though all characters on the
	Wireless information is uppercase, it is necessary to distinguish
	between upper case and lower case characters.
Channel	If you use the projector in 802.11AdHoc mode, select the channel, from 1 to
	11.
WEP Security	Select “Enable” or “Disable” the WEP (Encryption).
	When using WEP, select any of following items corresponding to this
	WEP; “Enable 40-bit”, “Enable 104-bit”, “Enable 128-bit”, and “Enable
	(802.1x”LEAP”).”
	When enabling WEP (Encryption), the image transfer speed may become
	slower.
WEP Key#1–Key#4	Set WEP key in the hexadecimal notation (0 to F). 5 bytes are set for 40-
	bit WEP, 13 bytes are set for 104-bit, and 16 bytes are set for 128-bit
	WEP. Four WEP keys can be set, however, the only one with check on
	its radio button is in effect. Both of the number and value of the WEP
	key in effect must be same as those of your computer and the access
	point.
	Depending on computers and access points, you may be allowed to
	select only one WEP key. In this case, use WEP key 1.
LEAP Username/Password	When selecting 802.1 x “LEAP” in WEP security, enter the user name
	and the password. Enter with ASCII 64-byte capital characters and one-
	byte characters. Consult your system administrator about the user name
	and the password.
APPLY button	Click the APPLY button to update. The screen to restart the projector will be
	displayed.
REFRESH button	Update and show the adjusted data.
RESTORE Factory Default
Settings button	Restore the settings to the values at the factory.

47