Sanyo PLC-XT20K, PLC-XT25K, PLC-XT20L* owner manual Wireless Mouse Operation, Remote Control Code

Part Names and Functions

Wireless Mouse Operation

The remote control can be used as a wireless mouse for your computer.

1	Before operating the wireless mouse, connect
	your computer and the projector with the
	supplied USB cable. (See page 22 for
	connection.)
	When the Pointer function is used, the
	wireless mouse is not available.
2	When a USB cable is connected to the
	computer and the projector, turn on the

projector first, then the computer. If you turn on the computer first, the wireless mouse function may not operate properly.

Remote Control Code

PRESENTATION POINTER button

Move the pointer on the screen with this button.

R-CLICK button

Acts as right (click) mouse button while the projector and a computer are connected with a USB cable.

L-CLICK button

Acts as left (click) mouse button while the projector and a computer are connected with a USB cable.

The eight different remote control codes (Code 1–Code 8) are assigned to this projector. Switching the remote control codes prevents interference from other remote controls when several projectors or video equipment next to each other are operated at the same time. Change the remote control code for the projector first before changing that for the remote control. See “Remote control” in the Setting Menu on page 57.

1	Press and hold the MENU and a number button (1–8)
	for more than five seconds to switch between the
	codes.
2	To initialize the remote control code, slide the RESET/
	ON/ALL-OFF switch to “RESET,” and then to “ON.”

The initial code is set to Code 1.

MENU button

Number buttons

RESET/ON/ALL OFF

Switch

Press and hold the MENU and a number button (1–8) that corresponds to the remote control code for more than five seconds to switch between the codes.

17