Sanyo PLC-XD2600 owner manual Standby mode, Timer

Setting

Standby mode

This function is available when operating the projector via network.

Network..... Supply the power to the network function even

after turning off the projector by pressing the ON/STAND-BY button on the remote control. You can turn on/off the projector via network, modify network environment, and receive an e-mail about projector status while the projector is powered off.

Eco............. Select Eco when you do not use the projector

via network. The projector’s network function will stop when turning off the projector, you can not turn on the projector via network.

Refer to the owner’s manual of “Network Set-up and Operation”.

✔Note:

•When selecting Network, the cooling fans may be running depending on the temperature inside the projector even if the projector is turned off.

•When Eco mode is selected and the projector is in Stand- by, the communication of RS-232C serial port is not available.

P-timer

This function allows you to change the setting of the P-timer and execute it.

Select one of the following options:

Count up	The P-timer display 000:00 appears on the
Count down	screen and the count starts (000:00–180:00)
	The time set in the Timer setting appears on
	the screen and the countdown starts.
Timer	Use the Point ▲▼ buttons to set the Timer
	(1–180 Min). Timer is available in Count
Start	down only. Factory default velue is 10 Min.
	It executes the count up or count down
	function. Press the SELECT button at
	Start and the indication changes into
	Stop. To stop Count up or Count down,
	press the SELECT button at Stop on the
	screen menu,then the indication changes
	into Restart. Press the SELECT button
	at Restart to resume Count up or Count
Reset	down.
	Reset the P-timer values.
	Press the SELECT button at Reset to return
	to the following value;
	Count up ... "000:00"
Exit	Count down ... Timer that you set
	To exit the P-timer operation.

P-TIMER

0

P-timer display

Start

Reset

Exit

Stop or Cancel the P-timer via Remote Control To stop the P-timer, press the P-TIMER button.

To cancel the P-timer, press and hold the P-TIMER button for a few seconds.

51