Sanyo PLC-XD2600 owner manual Appendix

		Appendix
	No image	– Check the connection between your computer or video equipment
		and the projector. See pages 14-16.
		– See if the input signal is correctly output from your computer. Some
		laptop computers may need to change the setting for monitor output
		when connecting to a projector. See your computer’s instruction
		manual for the setting.
		– It takes about 30 seconds to display an image after turning on the
		projector. See page 18.
		– Check the Input signal, color system, video system or computer
		system mode.
		– Make sure the temperature is not out of the specified Operating
		Temperature (41˚F–95˚F [5˚C–35˚C]).
		– When No Show is operating, the image cannot be displayed. Press
		the NO SHOW button or any other button on the remote control.
	No sound	– Check the audio cable connection from audio input source.
		– Adjust the audio source.
		– Press the Volume + button. See page 24.
		– Press the Mute button. See page 24.
		– When the AUDIO OUT is plugged-in, the projector's built-in speaker
		is not available.
		– Is the image projected? You will hear the sound only when the image
		is projected.
The color is strange..		– Check the Input signal, color system,video system or computer
		system mode.
		– Make sure the Blackboard is not selected on Image select
		menu. See pages 32, 39.

Some displays are not seen during the operation..

– Check the Display function. See page 45.

Auto PC adjustment function	– Check the Input signal. Auto PC adjustment function can not work
does not work..	when 480p,575p.720p,480i,575i,1035i or 1080i is selected. See
	page 29.

The setting does not remain after turning off power..

–Make sure you selected Store after adjusting setting. Some settings can not be stored if not registered with Store. See pages 34, 41.

Power management does not	– Power management function can not work while Freeze or No
work.	Show function is running. See page 50.
Capture function does not work..	– Check the connection and the input signal to see if there is signal.
Auto setup does not work properly..	– Make sure Off is not selected at any function of Auto setup. See page
	44.
	– Make sure On is not selected at the Ceiling function. See page 49.

Auto keystone function does not work even when the projector is tipped..

–Make sure the Auto keystone function is not set to Manual. Press the AUTO SETUP button on the top control. See pages 23, 44.

65