Sanyo PLC-XD2600 owner manual Part Names and Functions Rear Terminal

Part Names and Functions

Rear Terminal

① ② ③ ⑤ ⑥

⑦⑧ ④

①CONTROL PORT

When the projector is controlled by a computer, connect to this jack with serial control cable.

②COMPUTER IN 1 /S-VIDEO IN / COMPONENT IN

Connect output signal from a computer, component video output, RGB scart 21-pin video output or S-video output to this terminal. (pp.14-16).

③COMPUTER IN 2 / MONITOR OUT

–Connect analog RGB output signal from a computer to this terminal (p.14).

–This terminal can be used to output the incoming analog RGB and Component signal from

COMPUTER IN 1 /S-VIDEO IN /COMPONENT IN terminal to the other monitor (pp.14,16).

④AUDIO OUT (VARIABLE)

Connect an external audio amplifier to this jack (pp.14-16).

This terminal outputs sound from AUDIO IN terminal.

⑤VIDEO IN

Connect the composite video output signal to this jack (p.15).

⑥LAN Connection Terminal

Connect the LAN cable (refer to the owner’s manual of “Network Set-up and Operation”).

⑦AUDIO IN（Video)

Connect the audio output signal from video equipment connected to ⑤ to this jack. For a mono

audio signal (a single audio jack), connect it to L(MONO) jack. (pp.14-16).

⑧AUDIO IN (PC)

Connect the audio output signal from computer or video equipment connected to ② and ③ to this jack. (pp.14-16).