Kodak KKE PLUS, KKA, JAMT, J-E PLUS, E-PLUS SLIDE, ATS, BR Replacing the Mechanism Assembly, Dark

Replacements and Installations

Replacing the MECHANISM ASSEMBLY

SCREW (3)	SCREW
	DARK
LENS	SHUTTER
	SWITCH
MOUNT

MECHANISM

ASSEMBLY

SCREW

FOCUS KNOB

	AUTO FOCUS
A091_4022CCA	DEFEAT SWITCH
	(not shown)
A091_4022CA

Warning

Dangerous Voltage

[1]Disconnect the main power.

[2]Do the replacement procedure for the LOWER HOUSING ASSEMBLY.

[3]Cut and remove the necessary WIRE TIES.

[4]Disconnect the 2 wires from the CYCLE SOLENOID on the SMALL CIRCUIT BOARD.

[5]Pull the SMALL CIRCUIT BOARD up.

[6]Disconnect all wires connected to the

MECHANISM ASSEMBLY:

•1 yellow wire from CYCLE SWITCH

•1 orange wire from WIRE NUT

•1 green wire from POWER CORD

•2 green ground wires from the lower

MECHANISM ASSEMBLY

[7]Remove the FOCUS KNOB from the FRONT PANEL.

Important

For Auto-Focus models only, disconnect the short, gray wire connected to the AUTO-FOCUS DEFEAT SWITCH.

[8]Remove the 3 Torx SCREWS from the LENS MOUNT ASSEMBLY.

[9]Lift and move the LENS MOUNT ASSEMBLY up.

[10]Do the replacement procedure for the MOTOR.

[11]Remove the 3 Torx SCREWS from the

MECHANISM ASSEMBLY.

[12]Loosen the SCREW on the STABILIZER WALL approximately half way.

[13]Remove the SCREW from the DARK SHUTTER SWITCH and remove the SWITCH.

Caution

There might be a bind between the SELECT LEVER and the SELECT BUTTON when removing the MECHANISM ASSEMBLY. Do not use force; this might cause damage to the SELECT BUTTON.

[14]Remove the MECHANISM ASSEMBLY.

SM4530-1 – 30APR96 13