Kodak KKE PLUS, B Replacing the Lens Mount Assembly Auto Focus Model, AUTO-FOCUS Defeat Switch

SERVICE MANUAL

Caution

The TABS could break.

[3]Bend the 3 TABS of the LAMP BRACKET ASSEMBLY.

[4]Lift the top of the LAMP BRACKET ASSEMBLY up.

[5]Rotate and push the LAMP TERMINAL ASSEMBLY until it releases.

[6]Remove the LAMP TERMINAL ASSEMBLY.

Installing the LAMP SOCKET TERMINAL ASSEMBLY, Painted Models

[1]Do the replacement procedure for the LAMP SOCKET TERMINAL ASSEMBLY in reverse order and check the following during installation:

•Check that the LAMP EJECTOR is aligned correctly before you install the LAMP TERMINAL ASSEMBLY.

•Check that the LAMP TERMINAL ASSEMBLY wires are aligned correctly.

•Bend the 3 TABS down until they are flush with the top of the LAMP BRACKET ASSEMBLY. If the TABS break, use TOP PLATE SCREW 785130 to install a new TAB.

Replacing the LENS MOUNT ASSEMBLY - Auto Focus Model

LENS MOUNT ASSEMBLY

SCREW (3)

Warning

Dangerous Voltage

[1]Disconnect the main power.

[2]Do the replacement procedure for the LOWER HOUSING ASSEMBLY.

[3]Remove the FOCUS KNOB.

[4]Remove the short, gray wire connected to the

AUTO-FOCUS DEFEAT SWITCH.

Important

It is necessary to push the AUTO-FOCUS BRACKET backward and forward to allow access to the SCREWS on the LENS MOUNT ASSEMBLY.

[5]Remove the 3 SCREWS from the LENS MOUNT ASSEMBLY.

[6]Lift and remove the LENS MOUNT ASSEMBLY.

A100_0019GCA

A100_0019GA

Installing the LENS MOUNT ASSEMBLY - Auto Focus Models

[1]Do the replacement procedure for the LENS MOUNT ASSEMBLY in reverse order.

20 30APR96 – SM4530-1