Kodak J-E PLUS, KKE PLUS, KKA, JAMT, E-PLUS SLIDE, ATS, BR Adjusting the Slide Lift Lever Power

Adjustments

Adjusting the SLIDE LIFT LEVER POWER

SLIDE LIFT LEVER GUAGE TL-3001

SLIDE LIFT

LEVER

SELECT

LEVER (not shown)

A091_0016BCA

A091_0016BA

Warning

Dangerous Voltage

[1]Disconnect the main power.

Important

The older style MECHANISM SLIDE LIFT LEVER has an ECCENTRIC on it to do this adjustment.

[2]Do the removal for the MECHANISM ASSEMBLY.

[3]Place the MECHANISM ASSEMBLY on the MECHANISM RUNNING FIXTURE TL-3000.

[4]Energize the MECHANISM FIXTURE.

[5]Press and hold the SELECT LEVER down to move the SLIDE LIFT LEVER to the highest position.

[6]Measure the height of the SLIDE LIFT LEVER. Use SLIDE LIFT LEVER GAUGE TL-3001. The SLIDE LIFT LEVER should make contact with the low surface of the SLIDE LIFT LEVER GAUGE TL-3001;

the SLIDE LIFT LEVER should not make contact with the high surface of the SLIDE LIFT LEVER GAUGE TL- 3001.

[7]Bend the SLIDE LIFT LEVER until the adjustment is correct.

Adjustment Specification

Make a 5/16 in WRENCH to do this adjustment (see the Tools section). Connect a DIGITAL VOLT METER betweens PINS 1 and 3 (ZERO POSITION SWITCH). The DVM should measure • without a TRAY and 0 W with a TRAY installed.

SM4530-1 – 30APR96 29