Kodak KKE PLUS, KKA, JAMT, B Lever Assembly, Power Slide Lift Lever, Eccentrics, Direction Lever

Diagnostics

Malfunction			Check
The projector does not change cycles when	1.	If the CYCLE LEVER and the RATCHET
using a DISSOLVE CONTROL; the REMOTE		PLATE are dirty.
CONTROL and CONTROL PANEl BUTTONS		•	Clean and apply lubricant SUPER
operate correctly.
			LUBE TL-4276 to thE CYCLE LEVER
			and RATCHET PLATE.
		•	If this does not correct the malfunction,
			install a new CAM SHAFT ASSEMBLY.
SLIDE TRAY does not advance smoothly.	1. Check the SLIDE TRAY LATCH for correct
		alignment.
	2. Operate the projector in the forward
		direction.
		• Check that the INDEXER LEVER
			ASSEMBLY is in the correct alignment
			with the holes at positions A and B.
		•	Do the adjustment for the INDEXER
			LEVER ASSEMBLY.
		•	Check the condition of the LOCATOR
			LEVER, it should not be bent.
		•	Check the height of the SLIDE LIFT
			LEVER; the lower corner of the LIFT
			LEVER RAMP is parallel with the TOP
			HOUSING. If the height is not correct,
			do the adjustment for the MANUAL and
			POWER SLIDE LIFT LEVER
			ECCENTRICS.
SLIDE TRAY advances when “REVERSE” is	1.	Do the adjustment for the CYCLE
pressed.		SOLENOID.
	2. Check that the SPRING is on the
		DIRECTION LEVER.
	3. Check for a bind in the DIRECTION LEVER
		ASSEMBLY.
	4. Check that the DIRECTION LEVER LINK is
		in the correct position.
SLIDE TRAY does not rotate freely when the	1.	Press and release the SELECT BUTTON.
SELECT BUTTON is pressed down. The		• Check that the LOCATOR LEVER
projector has power.
			moves correctly and is not bent.
	2. Press and hold the SELECT BUTTON
		down.
		• Check the SLIDE LIFT LEVER RAMP
			for damage.
	3. Check the height of the SLIDE LIFT
		LEVER; the lower corner of the LIFT
		LEVER RAMP is parallel with the TOP
		HOUSING. If the height is not correct, do
		the adjustment for the MANUAL and
		POWER SLIDE LIFT LEVER
		ECCENTRICS.

SM4530-1 – 30APR96 49