Kodak AM, KKA, JA Replacing the Focus Shaft Assembly Auto Focus Models, Clamp Lever Screw, Spring

Replacements and Installations

Replacing the FOCUS SHAFT ASSEMBLY - Auto Focus Models

CLAMP LEVER	SCREW	FOCUS SHAFT
SPRING		SPRING

RACK LEVER (not shown)

FOCUS SHAFT SCREW

FOCUS MOTOR BRACKET

SPACER

E-RING

RACK SOLENOID

PLUNGER

LENS SUPPORT BRACKET

PHOTOCELL	AUTO-FOCUS
BRACKET		SCREW
	SWITCH
SPRING
	ASSEMBLY

A091_4029HCA

A091_4029HA

Warning

Dangerous Voltage

[1]Disconnect the main power.

[2]Do the replacement procedure for the LOWER HOUSING ASSEMBLY.

[3]Remove the FOCUS KNOB.

[4]Remove the short, gray wire from the AUTO-FOCUS DEFEAT SWITCH.

Important

It is necessary to push the AUTO-FOCUS BRACKET backward and forward to allow access to the SCREWS on the

LENS MOUNT ASSEMBLY.

[5]Remove the 3 SCREWS from the LENS MOUNT ASSEMBLY.

[6]Lift and remove the LENS MOUNT ASSEMBLY.

[7]Remove the FOCUS SHAFT SPRING from the LENS MOUNT BRACKET.

[8]Remote models only: Remove the SPRING from the CLAMP LEVER on the LENS MOUNT BRACKET.

[9]Remove the SPRING from the PHOTOCELL BRACKET.

[10]Remove the E-RING and SPACER from the FOCUS SHAFT ASSEMBLY.

[11]Remove the SCREW from the LENS SUPPORT BRACKET.

[12]Lift and remove the LENS SUPPORT BRACKET.

[13]Remote models: Remove the AUTO-FOCUS SWITCH ASSEMBLY.

[14]Remote models: Remove the SCREW from the RACK SOLENOID ASSEMBLY.

[15]Remote models: Remove the RACK SOLENOID ASSEMBLY and PLUNGER.

[16]Remote models: Remove the SCREW from the FOCUS MOTOR BRACKET ASSEMBLY.

SM4530-1 – 30APR96 23