Kodak E-PLUS SLIDE, KKE PLUS, KKA, JAMT, J-E PLUS, B Pad, Clamp PAD, AUTO-FOCUS Assembly Target Slide

SERVICE MANUAL

light path

NULL position

TAB

A091_4027BCA	CLAMP LEVER
	PAD
A091_4027BA

[12]Manually move the CLAMP PAD ASSEMBLY until the TAB is in the NULL position.

T-BAR TL-3003 hole

FAN CAP

light image

	CLAMP PAD
AUTO-FOCUS	ASSEMBLY
TARGET SLIDE	A091_4030BCA
TL-3002	A091_4030BA

Warning

Dangerous Voltage

[13]Connect the main power.

Important

It is necessary to make a FAN COVER TOOL. See the Tools section.

[14]Install the FAN COVER TOOL over the FAN area and the LAMP MODULE. See the Tools section.

[15]Install and hold the AUTO FOCUS TARGET SLIDE TL-3002 until it is fully seated in the GATE MECHANISM.

[16]Set the projector to the LO-LAMP position.

[17]Observe the image of the focus light path on the bottom of the FAN CAP; the light path should be in the center of the hole in the FAN CAP.

[18]Bend the CLAMP PAD ASSEMBLY until the image is in the center of the hole in the FAN CAP.

[19]Assemble the PHOTOCELL MASK, FILTERS and PHOTOCELL BOARD.

34 30APR96 – SM4530-1