Replacing the rear blotter strips
Blotter strips collect ink overflow. They should be replaced when there is a
1.Remove the output tray. The rear blotter strips are located in the two drawers underneath the baffle.
2.Open the one of the drawers by pushing it in a little and lifting up slightly, then pull it out.
3.Peel off the soiled blotter strip.
4.Peel the backing away from the new blotter strip.
5.Align the blotter strip in the channel. Be sure it is properly aligned before pressing the adhesive side into the channel.
6.Press the blotter strip firmly into place.
7.Repeat Steps 2 - 5 for the other blotter strip.
8.Close the drawer(s) by pushing it in and sliding it down slightly. This will lock the drawer in place.
9.Replace the output tray.
|