Kodak A-61555 manual Enhanced Printer and Patch Readers for more

Messages	ID#	Operator Message
Clean upper imaging guide	293, 304	The upper imaging guide is dirty or there may be a small piece of
		paper in the imaging guide area.
		• Clean the imaging guides. See Chapter 5, Maintenance for
		procedures.
Document count exceeded	124	The document counter is larger than the maximum configured
maximum value		value.
		• Reconfigure the scanner to allow a larger value for the
		document counter. Refeed the document set.
Document too dark to deskew	143	Informational message. The scanner was unable to find the
		document edges to determine the skew angle. A full-width, non-
		deskewed image has been created.
		• The document is too dark.
		• The image is too large.
		• Rescan using a fixed-sized cropping window.
Document too long	35, 36, 183	A document was measured which exceeded the configured
		maximum allowable length. This may be due to a document
		overlap.
		• Check the host monitor to see if there are any overlapped
		documents that may need to be rescanned.
		This condition may also be caused by poor document
		separation.
		• Replace the separation roller tires and pre-separation pad.
		See Chapter 5, Maintenance for procedures.
Front calibration failed	110	The front imaging path calibration failed.
		• Clean the imaging guides. See Chapter 5, Maintenance for
		procedures.
		• Try to calibrate the scanner again. Be sure you are using the
		correct calibration target. See Chapter 3, “Calibrating the
		Scanner”.
		• If the problem persists, call Service.
Front calibration succeeded	111	Informational message. The front image path has been
		successfully calibrated.
Image address overflow	120	One of the image address fields is not large enough for the next
		image address (i.e., level 2 field width is 2, but the next level 2
		value is 100).
		• Define the image address field to be wider.
Image calibration is suggested	109	• Calibrate the scanner when the current batch of documents
		has completed.
Image outside document area	177	Based on relative cropping parameters, the image to be
		generated from this document would be outside the document
		area.
		• Make sure the relative cropping offset, width and length are
		correct and that the correct document is being scanned.
Ink cartridge not installed	282	An attempt was made to use the Enhanced Printer without a ink
		cartridge installed.
		• Be sure the cable is properly connected to the printer carrier
		and the ink cartridge is installed in the printer carrier. See
		Chapter 4, The Enhanced Printer and Patch Readers for more
		information.
		NOTE:The ink cartridge must be installed before turning on the
		scanner.

6-6 A-61555 April 2009