Feeder Capacity: The input elevator can hold up to 500 sheets of 75 g/m2 (20 lb.) paper.
Before you begin scanning documents, make certain the documents can be fed through the scanner easily.
•A stack of documents to be fed into the scanner must be arranged so the leading edges of all documents are aligned under the feed module; this allows the feeder to introduce documents into the scanner one at a time.
•Staples and paper clips on documents may damage the scanner and documents. Remove all staples and paper clips before scanning.
•Documents with missing corners, perforated edges, hole punches in the margins, irregular and curled edges, torn, damaged, or crushed pages can be transported successfully through the scanner. These documents may require manual feeding.
•When scanning
•If in doubt about whether a specific damaged document can be transported through the scanner, place the document in a clear protective sleeve with the lead edge of the document aligned with the folded edge of the sleeve. Sleeves should be manually fed, one at a time, folded edge first, while using the gap release button. Ultrasonic
NOTE: When scanning documents in a clear protective sleeve, the input elevator side guides must be adjusted to accommodate the width of the sleeve.
|