Kodak A-61555 manual Final cleaning steps

Page 86

The Count Only screen will be displayed.

5.Touch Scan.

6.Remove the transport cleaning sheet from the output tray and place it in the center of the input elevator in landscape orientation with the adhesive side down and touch Scan.

7.When finished, touch End Job.

NOTE: When the transport sheet gets dirty, discard it and use a new one.

Final cleaning steps	When finished running the transport cleaning sheet:
	1.	Open the pod.
	2.	Wipe the exposed side of the upper and lower imaging guides with a
		lint-free cloth.
	3.	Close the pod and scan a test image to ensure image quality.

5-14	A-61555 April 2009

Image 86

Contents Page Contents Enhanced Printer/Patch Readers Appendix B Introduction New features Scanner features System requirements Supporting documentationContacting Service and Support Phone numbers United States and CanadaSafety information MsdsEMC statements Environmental informationConnection Power systemAcoustic emission NetzanschlußGetting Started Scanner components Front viewPage Page Internal components Rear view Using the Scanner Turning the scanner onApril Materials Turning the scanner off Starting and stopping scanningDocument preparation Page Position Adjusting the input elevatorSelecting your feeding Locking the side guidesPage Output tray options Adjusting the output trayAdjusting the side guides Page Adjusting the end stop Adjusting the angle of the output trayPage Exit deflector Page Adjusting the short document tray Adjusting the height of the scanner Feeding documents using multi-feed detection Automatic feedingContinuous feeding Manual feeding Feeding documents that require special handling Using the operator control panel touchscreen Settings screen Page Selecting the tone Selecting a language Page Page Image Calibration Udds Calibration Printer units For millimetersFragile Feed mode Idle screen Message windowImage Address information Operator LogAccessing scanner InformationCount only mode Performing a Print test Lowering the elevator Page Select Print Offset. The following screen will be displayed Disabling the PrinterPage Performing a self test Using function keys when scanning ScanningChanging image address levels Automatically pausing and resuming the scanner Manually pausing and resuming the scannerPower Saver mode Viewing messages Resuming from Power Saver modeEnhanced Printer and Patch Readers Enhanced Printer overviewPrinter specifications Font sizeChanging print positions Changing the front horizontal print positionChanging the rear Horizontal print positionPage Page Replacing the ink cartridge Page Replacing the front blotter strips Page Replacing the rear blotter strips Patch types Patch function overviewPatch Readers Patch code placement Toggle PatchMaintenance Cleaning frequency chart Cleaning tools and materials Procedure Start Middle Start of new Day ShiftSupplies, consumables and accessories Ordering partsCleaning procedures Cleaning the rollers Cleaning the separation roller tires Cleaning the feed module tires Close the printer access cover April Edges of the transport Cleaning the imaging Guides basic cleaningCleaning the imaging guides thorough cleaning Upper imaging guideLower imaging guide Cleaning sheet Running a transportFinal cleaning steps Replacement procedures Align these areas IMPORTANTDo not overstretch the tire it may tear Locking tab Replacing the separation roller or separation roller tires Replacing the imaging Replacing the preSeparation pad GuidesTroubleshooting Accessing Operator LogAccessing the Operator Log from the Scan Validation tool Page Page Message listing ID#Enhanced Printer and Patch Readers for more Image Processing Guide for valid values Informational message. The pod was closed April Numerical message Contacting Service Problem solving Problem Possible SolutionIf you are using iThresholding, reduce the Contrast value Resolution Printer Accessory Ultralightweight Paper Feed ModuleBackground Accessory Kodak Manual Feeder Appendix B Specifications

Final cleaning steps

A-61555 April 2009