Kyocera VLSG-01 manual System Overview, VanLink System ENG Vehicle Configuration

Page 19

VANLINK SYSTEM GUIDE

SECTION 1

VANLINK SYSTEM OVERVIEW

1.1SYSTEM OVERVIEW

The Troll Systems VanLink remote broadcast van control interface is a comprehensive and dynamic system designed to be integrated into vehicles utilized in Electronic News Gathering functions in the field. Refer to Figure 1–1through Figure 1–3.

Van External

Control Panel

with QPT set

to Remote

CONTROL

CONTROL

CONTROL

Field Vehicle with Tx, GPS and Magnetometer controlled remotely by studio operator

Van External

Control Panel

with QPT set

to Remote

Troll Systems V750

Remote Site Controller

T O U C H S T A R

7S 5 0

Transmitter

to V750 serial input

EVDO to V750 Ethernet

with Static IP or Dynamic DNS

QPT - 90/115 with

Local and Remote Controller

FEEDBACK

Van Tx Antenna with Pan and Tilt

Rooftop or Antenna

Mounted IMU

COMM

12 wire Nycoil from V750 to Tx Antenna

COMM

WAN

CONTROL

Figure 1–1. VanLink System ENG Vehicle Configuration

VanLink System featuring TouchStar™ Technology - Troll Systems Corporation

Document VLSG-01 - 10/21/08

VanLink System Overview 1-1

Image 19
Contents VanLink System Installation Guide Troll Systems Corporation Table of Contents C100 User Interface Software Requirements SummaryVanlink Equipment Components Required HardwareTerm Definition ABBREVIATIONS, ACRONYMS, TermsABBREVIATIONS, ACRONYMS, Terms Packaging WarrantyVanLink Component Set-up and Operation Conventions Used in this DocumentHint This format is used for all hints HintsContact Information Introduction Do Not Service or Adjust Alone General Safety PrecautionsHazard Advisory Placards/Signs Electrical Power/Shock Hazards VanLink Safety ConsiderationsCoincidental Damage to Equipment in Cabinets Be Familiar With Resuscitation TechniquesLifting/Handling Hazards Electrostatic Discharge Sensitive Esds Components Safety Considerations S-5 Page System Overview VanLink System ENG Vehicle ConfigurationVanLink IMU Configuration VanLink System FeaturesVanLink Remote Studio Configuration Remote Control from the Studio or Control CenterMaster Controller Software Requirements SpecificationsRequired System Components Hardware RequirementsIntroduction Safety RecommendationsCable Requirements Installation RequirementsPower Requirements Rack InstallationRunning Cables 3.2 V750 Cable and Connector RequirementsTypical Network Configuration Pan and Tilt Cabling and Connector RequirementsEVDO/3G Router Connectivity Master Controllers and TNS AccessibilityIP Connectivity 3.4 GPS/IMU ConnectivityTypical VanLink Network Configuration 5.1 GPS/IMU Mounting Considerations GPS/IMU AssemblyTypical Network Configuration for VanLink 1 GPS/IMU Mounting ConsiderationsVanLink GPS GPS/IMU AssemblyAntenna Calibration CalibrationRemote and Local Control Magnetometer CalibrationTransmitter Control / Available Options Operating RequirementsSection Engineering Drawings Page Page Page Page Page Page