Kyocera VLSG-01 manual

Page 18

NOTES

User Manual S-6

VanLink System featuring TouchStar™ Technology - Troll Systems Corporation Document VLSG-01 - 10/17/2008

Image 18

Contents VanLink System Installation Guide Troll Systems Corporation Table of Contents C100 User Interface Required Hardware SummaryVanlink Equipment Components Software RequirementsABBREVIATIONS, ACRONYMS, Terms Term DefinitionABBREVIATIONS, ACRONYMS, Terms Warranty PackagingConventions Used in this Document VanLink Component Set-up and OperationHints Hint This format is used for all hintsContact Information Introduction General Safety Precautions Do Not Service or Adjust AloneHazard Advisory Placards/Signs VanLink Safety Considerations Electrical Power/Shock HazardsBe Familiar With Resuscitation Techniques Coincidental Damage to Equipment in CabinetsLifting/Handling Hazards Electrostatic Discharge Sensitive Esds Components Safety Considerations S-5 Page VanLink System ENG Vehicle Configuration System OverviewVanLink System Features VanLink IMU ConfigurationRemote Control from the Studio or Control Center VanLink Remote Studio ConfigurationHardware Requirements SpecificationsRequired System Components Master Controller Software RequirementsSafety Recommendations IntroductionRack Installation Installation RequirementsPower Requirements Cable Requirements3.2 V750 Cable and Connector Requirements Running CablesPan and Tilt Cabling and Connector Requirements Typical Network Configuration3.4 GPS/IMU Connectivity Master Controllers and TNS AccessibilityIP Connectivity EVDO/3G Router ConnectivityTypical VanLink Network Configuration 1 GPS/IMU Mounting Considerations GPS/IMU AssemblyTypical Network Configuration for VanLink 5.1 GPS/IMU Mounting ConsiderationsGPS/IMU Assembly VanLink GPSMagnetometer Calibration CalibrationRemote and Local Control Antenna CalibrationOperating Requirements Transmitter Control / Available OptionsSection Engineering Drawings Page Page Page Page Page Page