Kyocera VLSG-01 manual Troll Systems Corporation

Page 2

NOTICE

The information in this document incorporates proprietary rights of

Troll Systems Corporation

24950 Anza Avenue

Valencia, CA 91355, U.S.A.

Any party accepting this document acknowledges that it contains proprietary confidential information and agrees that it shall not be duplicated in whole or in part, nor disclosed to others without the written consent of Troll Systems Corporation.

© 2008 Troll Systems Corporation

Image 2

Contents VanLink System Installation Guide Troll Systems Corporation Table of Contents C100 User Interface Required Hardware SummaryVanlink Equipment Components Software RequirementsABBREVIATIONS, ACRONYMS, Terms Term DefinitionABBREVIATIONS, ACRONYMS, Terms Warranty PackagingConventions Used in this Document VanLink Component Set-up and OperationHints Hint This format is used for all hintsContact Information Introduction Hazard Advisory Placards/Signs General Safety PrecautionsDo Not Service or Adjust Alone VanLink Safety Considerations Electrical Power/Shock HazardsLifting/Handling Hazards Be Familiar With Resuscitation TechniquesCoincidental Damage to Equipment in Cabinets Electrostatic Discharge Sensitive Esds Components Safety Considerations S-5 Page VanLink System ENG Vehicle Configuration System OverviewVanLink System Features VanLink IMU ConfigurationRemote Control from the Studio or Control Center VanLink Remote Studio ConfigurationHardware Requirements SpecificationsRequired System Components Master Controller Software RequirementsSafety Recommendations IntroductionRack Installation Installation RequirementsPower Requirements Cable Requirements3.2 V750 Cable and Connector Requirements Running CablesPan and Tilt Cabling and Connector Requirements Typical Network Configuration3.4 GPS/IMU Connectivity Master Controllers and TNS AccessibilityIP Connectivity EVDO/3G Router ConnectivityTypical VanLink Network Configuration 1 GPS/IMU Mounting Considerations GPS/IMU AssemblyTypical Network Configuration for VanLink 5.1 GPS/IMU Mounting ConsiderationsGPS/IMU Assembly VanLink GPSMagnetometer Calibration CalibrationRemote and Local Control Antenna CalibrationOperating Requirements Transmitter Control / Available OptionsSection Engineering Drawings Page Page Page Page Page Page