Kyocera VLSG-01 manual Introduction, Safety Recommendations

Page 23

VANLINK SYSTEM GUIDE

SECTION 2

VANLINK SYSTEM REQUIREMENTS

2.1INTRODUCTION

This section provides information detailing the system requirements and theory of operation of the Vanlink Control System. The following topics are discussed:

Safety Recommendations

System Requirements

Theory of operation and recommendations

2.2SAFETY RECOMMENDATIONS

Equipment installation and operation should only be performed by qualified personnel that are familiar with the type of equipment being installed.

The following guidelines will help ensure your safety and protect the equipment from damage. However, these guidelines do not cover all potentially hazardous situations you might encounter during system installation. Refer also to the Safety Considerations of this guide for additional safety information.

Always disconnect all power connections before installing or removing the Vanlink System and its associated components (i.e. the V750 Master Controller).

Keep the rack and/or installation area clear and free of dust during and after installation.

Keep tools and chassis components away from walk areas.

Comply with all local safety laws and guidelines.

Do not wear loose clothing, jewelry (including rings and chains), or other items that could get caught in the equipment. Fasten or remove loose ties, scarves, sleeves, and other items before you start installation procedures.

Equipment grounding must meet local and national electrical codes.

VanLink System featuring TouchStar™ Technology - Troll Systems Corporation

Document VLSG-01 - 10/21/08

VanLink System Requirements 2-1

Image 23
Contents VanLink System Installation Guide Troll Systems Corporation Table of Contents C100 User Interface Software Requirements SummaryVanlink Equipment Components Required HardwareTerm Definition ABBREVIATIONS, ACRONYMS, TermsABBREVIATIONS, ACRONYMS, Terms Packaging WarrantyVanLink Component Set-up and Operation Conventions Used in this DocumentHint This format is used for all hints HintsContact Information Introduction Hazard Advisory Placards/Signs General Safety PrecautionsDo Not Service or Adjust Alone Electrical Power/Shock Hazards VanLink Safety ConsiderationsLifting/Handling Hazards Be Familiar With Resuscitation TechniquesCoincidental Damage to Equipment in Cabinets Electrostatic Discharge Sensitive Esds Components Safety Considerations S-5 Page System Overview VanLink System ENG Vehicle ConfigurationVanLink IMU Configuration VanLink System FeaturesVanLink Remote Studio Configuration Remote Control from the Studio or Control CenterMaster Controller Software Requirements SpecificationsRequired System Components Hardware RequirementsIntroduction Safety RecommendationsCable Requirements Installation RequirementsPower Requirements Rack InstallationRunning Cables 3.2 V750 Cable and Connector RequirementsTypical Network Configuration Pan and Tilt Cabling and Connector RequirementsEVDO/3G Router Connectivity Master Controllers and TNS AccessibilityIP Connectivity 3.4 GPS/IMU ConnectivityTypical VanLink Network Configuration 5.1 GPS/IMU Mounting Considerations GPS/IMU AssemblyTypical Network Configuration for VanLink 1 GPS/IMU Mounting ConsiderationsVanLink GPS GPS/IMU AssemblyAntenna Calibration CalibrationRemote and Local Control Magnetometer CalibrationTransmitter Control / Available Options Operating RequirementsSection Engineering Drawings Page Page Page Page Page Page