Kyocera VLSG-01 manual C100 User Interface

Page 4

Master Controller Software Requirements	1-4
Introduction	2-1
Safety Recommendations	2-1
Installation Requirements	2-2
Power Requirements	2-2
Rack Installation	2-2
Rack Space Requirements	2-2
Cable Requirements	2-2
Running Cables	2-3
V750 Cable and Connector Requirements	2-3
Pan and Tilt Cabling and Connector Requirements	2-4
GPS/IMU Connectivity	2-5
EVDO/3G Router Connectivity	2-5
IP Connectivity	2-5
Master Controller(s) and TNS Accessibility	2-5
Typical Network Configuration for VanLink	2-7
GPS/IMU Mounting Considerations	2-7
GPS/IMU Assembly	2-7
GPS/IMU Mounting Considerations	2-7
VanLink GPS	2-8
Calibration	2-9
Magnetometer Calibration	2-9
Antenna Calibration	2-9
Remote and Local Control	2-9
Operating Requirements	2-10
Transmitter Control / Available Options	2-10
Introduction	3-1

C100 User Interface -2

VanLink System featuring TouchStar™ Technology - Troll Systems Corporation

Document VLSG-01 - 1/11/2007

Image 4

Contents VanLink System Installation Guide Troll Systems Corporation Table of Contents C100 User Interface Summary Vanlink Equipment ComponentsRequired Hardware Software RequirementsABBREVIATIONS, ACRONYMS, Terms Term DefinitionABBREVIATIONS, ACRONYMS, Terms Warranty PackagingConventions Used in this Document VanLink Component Set-up and OperationHints Hint This format is used for all hintsContact Information Introduction Do Not Service or Adjust Alone General Safety PrecautionsHazard Advisory Placards/Signs VanLink Safety Considerations Electrical Power/Shock HazardsCoincidental Damage to Equipment in Cabinets Be Familiar With Resuscitation TechniquesLifting/Handling Hazards Electrostatic Discharge Sensitive Esds Components Safety Considerations S-5 Page VanLink System ENG Vehicle Configuration System OverviewVanLink System Features VanLink IMU ConfigurationRemote Control from the Studio or Control Center VanLink Remote Studio ConfigurationSpecifications Required System ComponentsHardware Requirements Master Controller Software RequirementsSafety Recommendations IntroductionInstallation Requirements Power RequirementsRack Installation Cable Requirements3.2 V750 Cable and Connector Requirements Running CablesPan and Tilt Cabling and Connector Requirements Typical Network ConfigurationMaster Controllers and TNS Accessibility IP Connectivity3.4 GPS/IMU Connectivity EVDO/3G Router ConnectivityTypical VanLink Network Configuration GPS/IMU Assembly Typical Network Configuration for VanLink1 GPS/IMU Mounting Considerations 5.1 GPS/IMU Mounting ConsiderationsGPS/IMU Assembly VanLink GPSCalibration Remote and Local ControlMagnetometer Calibration Antenna CalibrationOperating Requirements Transmitter Control / Available OptionsSection Engineering Drawings Page Page Page Page Page Page